Servis-Rhino 4211B manual Assembling Quick Attach Device

ASSEMBLY

ASSEMBLY

5.On level ground, tilt the attachment down 90 degrees and lower it to the ground. Lower the loader further to slightly raise the front of the tractor of the tractor off the ground. Drive the tractor in reverse while the attachment is on the ground for 20-30 feet to insure the attachment does not disconnect. If the attachment disconnects during this process, discontinue the use of attachment and contact your dealer.

Do not use an attachment that is not securely attachment that is not securely attached to the quick hitch. The attachment could fall resulting in severe crushing injuries or death to the operator or bystanders.

Assembling Quick Attach Device

Quick attach device can be installed using tools ordinarily available. Torque all hardware to specifications listed in loader operator’s manual. Shut off the tractor engine and engage the tractor brakes during installation.

Only quick attach, skid steer compatible attachments can be used with the quick attach device. Pin on style attachments can be used on the loader, but necessitate removal of the quick attach device and relocation of the bucket level indicator.

All references to left and right used in these instructions are as they would appear to the operator standing at the rear of the unit facing forward.

1.Quick attach device is pre-assembled at the factory.

2.Unband the quick attach device and wood blocks. (Figure Asm-L-0012)

4211B 02/10 Assembly Section 3-10

© 2010 Alamo Group Inc.