Trouble-Shooting, Noaa Standby mode, Noaa Off mode

NOAA Weather Radio (continued)

NOAA Standby mode:

Stand by mode will mute the weather radio until an alert broadcast is received. While the radio is on, press “NOAA ON/OFF” once to enter NOAA standby mode. The “STANDBY” icon appears and the sound will mute. When an NWS (NOAA) alert broadcast is received, the unit will automatically switch to “NOAA On mode” and broadcast for 5 minutes.

NOAA Off mode:

While the radio is in Standby mode, press “NOAA ON/OFF” once to switch off weather radio completely.

NOTE: To conserve battery power, it is recommended to always use the adapter to power the unit while the weather radio is on. The radio can still operate with backup batteries alone during power outages.

Trouble-Shooting

Disconnected Signals

•If the receiver unit does not receive a transmission from a remote unit channel for 1 hour, the display will show dashes. To correct this problem:

1.Go to the remote location of that channel to check that the unit is properly positioned, within the appropriate transmission range.

2.If new batteries are faulty on the initial installation, install fresh

batteries. If you did not notice the Low Battery icon warning and the product performed correctly after initial set up, the batteries have lost their charge. Replace batteries (see the Power Sources

section of this manual.)

3.Check to make sure the transmission path is clear of obstacles and interference.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

Modifications not authorized by the manufacturer may void users authority to operate this device.

Note: FCC ID: L5CW044TX-F (transmitter)