Power Sources (continued)
Low Battery Warning: when the batteries on the receiver unit or the remote unit are low, the Low Battery Indicator icon will light up on the relevant displays. Follow the steps above to replace the batteries.
A maximum of 3 remote sensor units can be registered. One remote sensor is included. To purchase additional Remote Sensors (Taylor model 1438), please call
Setting the Time & Alarm
1. Radio-Controlled Clock
The Home Receiver will automatically start synchronizing the clock after battery/adapter installation or reset. To force searching of the
If the “ ” icon disappears afterwards, Atomic time signal is not available at the moment. Try other locations later. Place the unit away from source of interference such as mobile phones, appliances, TV etc.
When the Atomic Clock is successfully synchronized, a full strength antenna icon ( ) will appear. The Atomic Clock will have a daily synchronization at 2:03 am everyday. Each reception cycle is 2.5 minutes minimum and 10 minutes maximum.
2. U.S. Time Zone & DST Setting
Press the “ZONE“ button inside the receiver's battery compartment to select between Pacific (“PA”), Mountain (“MO”), Central (“CE”) and Eastern (“EA”) time zones. Press “CLOCK” on the front of the receiver to confirm the zone selection.
Press and hold “ZONE” to enter DST (Daylight Saving Time) setting mode. Press “p“or “q“ on the front of the unit to enable or disable the DST setting. Press “ZONE” to confirm DST setting.
7