Tanaka TLE-550 manual Installation of the AIR Cleaner

TLE-550 Owner’s Manual

4.INSTALLATION OF THE AIR CLEANER

a.Mount the air cleaner body to the cleaner bracket using 4 pcs. 5 x 14 bolts, 4 pcs. 5mm washers and 4 pcs. 5mm spring washers. (Fig. 9)

b.Attach the cleaner core to the hose securing it with the wire band. Insert the cleaner sponge onto the core then insert the core into the cleaner body.

NOTE: Make sure both rims on the end of the core are inside of the cleaner body. (Fig. 10 & 11)

WARNING: When attaching the cleaner core to the hose, be careful not to move the orifice pipe. The wire bond must be secured to the orifice and the cleaner core or the hose may become damaged when it is tightened. (Fig. 10 & 11)

c. To install carb side air cleaner, set the provided cleaner sponge in cleaner body and install the pre-assembled cleaner cap on the cleaner body. Secure the cap with 5 x 35mm screw, the collar and 5mm nut by slightly bending the clamps over the cap. (Fig. 12)

d. Clamp the cleaner hose and the protection tube onto handle A using the long clamp. Hook the 0-ring with the hose stay on recoil starter. Then clamp the protection tube onto the handle right above the air cleaner with the shorter clamp band. (Fig. 13, 18)

www.tanakapowerequipment.com 6 custsvc@tanaka-ism.com