MTD MMZ 2554, MMZ 2560, MMZ 2254 service manual

Page 12

e.Push the throttle control to a position a third of the way between slow and fast.

f.Insert the key in the ignition and start switch and turn the switch to “On”.

g.Gasoline Engine: If the engine is cold, push the choke to the on position.

h.Turn the ignition key in a clockwise direction to the “Start” position until the engine starts.

Note: Do not hold the key in the “Start” position for more than 10 seconds or you

may damage the starter. If the engine does not start in this time, wait about 30 seconds and try again.

i.Gasoline Engine: Once the engine starts, push the choke on halfway and as the engine warms, push the choke off all the way.

2.Operating the Mower: Operating a zero-turning-radius mower is not like operating a tractor-type riding mower. The zero-turning- radius mower is much more maneuverable and much less fatiguing to operate. However, getting used to the fingertip control of the zero-turning-radius mower takes some practice. We strongly rec- ommend that you locate a “test area” where you can operate the mower for about 30 minutes without being disturbed.

a.Get into the operator’s seat.

b.Start the engine.

c.Use the transport lever to raise the mowing deck to the transport position. Make sure the blade clutch switch is off.

d.After the engine has warmed, adjust the throttle to the fast position.

e.Release the parking brake.

f.Fold in the steering levers to the operating position.

WARNING:

When operating this mower forward, do not allow the steering levers to return to the neutral position on their own. Always maintain a firm grip on the steering levers, operate them smoothly and avoid any sudden movements of the levers when starting or stopping.

g.To go forward, move both steering levers slightly forward and the mower will slowly move forward. The farther you move the levers forward the faster the mower will go for- ward.

h.To back up, move both steering levers slightly backward and the mower will slowly move backward. The farther you move the levers backward the faster the mower will go backward.

12

Image 12
Contents Commercial Riding Mower Table of Contents Forward Safety Precautions GeneralRelated to Fuel When Mowing Specifications Operating Instructions ControlsPage Initial Adjustments Seat Adjustment Lever The SeatCheck the fluid levels and tires Vice SJ Lubricate all fittings listed in the maintenance section Break-In And OperationStart the Engine Page Maintenance and Service Mower DeckParking the Mower Removing the Mower DeckChanging a Blade Changing the Blade Drive Belts Changing the Spindle Assembly Stop the engine and remove the key from the ignition switchHydraulic Oil Electrical Circuit Draining Hydraulic OilBattery Removal Installing the BatterySpecific Freezing Gravity Temp F Jump Starting Page Tires Inflation PressureBrakes Hydraulic System Hydraulic Oil Tank and FilterRemoving the cap to prevent dirt from contaminating the oil Page To Put the Mower Back in Service StorageMaintenance Schedule Daily ChecksEvery 25 Hour Checks Weekly or Every 50 Hour ChecksYearly Checks Check the oil in the hydraulic reservoirLubrication Chart Wiring Diagram Page Equipment TWO-YEAR Limited Warranty