Figure. 6 | Linch Pins | Linch Pins |
| Height of Cut Clevis Pin |
|
e.Remove six linchpins (See Fig. 6) (4) from the deck and (2) from the front of the mower. Remove the linchpins on the left and right rear side of the cutter deck (2); remove the linchpins on the left and right front side of the cutter deck (2); and remove the linchpins on the front of the mower (2).
f.Turn front caster wheels outward.
g.Shift the deck toward the ignition switch side of the mower and remove.
h.To install reverse the process.
2.Changing a Blade:
a.Jack up the front of the mowing deck about one foot and block it in that position.
b.Wrap a rag around one end of the blade and grasp it to pre- vent it from turning, or secure the blade by placing a block of wood between the blade and the deck housing.
c.Use a
d.Remove the hex nut using a
e.Remove the hex nut.
f.To replace the blade reverse the above process and tighten nut to
14