MTD 435 Making Adjustments, Replacing Rear Flap, Adjusting Handle Height, Adjusting Carburetor

Replacing Rear Flap	• Attach the new flap and new rod to deck, bending
• To remove rear flap, cut off the flat end of the wire	the ends of the new rod over to secure to deck.
rod which secures it to the deck. See Figure 15 .		Rear Discharge
	Handle	Door
	Bracket		d
			o
			R
			e
			r
			i
			W	Handle
			Rear Flap	Bracket
			Figure 15

SECTION 8: MAKING ADJUSTMENTS

Adjusting Handle Height

Your mower is shipped with the handle in the higher height position. To lower height, proceed as follows.

•Remove the starter rope from the rope guide.

•Remove the upper handle by removing the hand knobs and carriage bolts. Lay upper handle out of the way, being careful not to bend or kink cables.

•Remove the hairpin clips from the weld pins on the handle brackets. Refer to Figure 4 . Press out on the legs of the lower handle. Remove lower handle from the mower.

•Turn the lower handle around so the notch on the bottom of the lower

handle is facing forward
as shown in the box
here. Reassemble,	Lower	Notch
placing the bottom
	Handle
holes in the handle over
the weld pins in the
handle mounting
bracket.

•Reassemble the upper handle to the lower handle.

•Insert hairpin clips in the inner holes of the weld pins and attach the starter rope as instructed in the “Assembling Your Lawn Mower” section.

Adjusting Cutting Height

IMPORTANT: All wheels must be placed in the same relative position. For rough or uneven lawns, move the height adjustment lever to a higher position. This will help stop scalping of the grass.

An adjusting plate and
	Adjustment
thumb lever at each wheel
position provides cutting	Lever
height adjustment. Each
adjusting plate has nine
height positions. Height of
cut will change when you
move the thumb lever
from one position to
another.

•Simply depress the lever towards the

wheel and move the lever assembly to desired position. See the illustration in the box above.

Adjusting Carburetor

NOTE: A dirty air cleaner may cause an engine to run rough too. Make sure that the air cleaner is clean and attached to the carburetor before deciding to adjust the carburetor.

WARNING: If any adjustments are made to the engine (e.g. carburetor) while the engine is running, keep clear of all moving parts. Be careful of heated surfaces like the muffler.

To adjust carburetor, please follow the engine manual.

14