Multiquip QP-301TH PRE-SETUP Pump, Read safety instructions at the beginning of manual

Page 16

Before Starting

1.Read safety instructions at the beginning of manual.

2.Place pump as near to water as possible,onafirmflat,levelsurface.

3.Toprimepump,removefillcap(Figure2)andfillpumpcasing with water. If the pump casing is not filled with water before starting, it will not begin pumping.

CAUTION :

Pump casing must be filled with water before using pump. Otherwise pump will not be able to begin pumping.

WARNING :

DO NOT open fill cap if pump is hot! Water inside may be under pressure.

4.Checkforleaksbetweenpumpandengine.Ifwaterisleaking between the pump and engine housing, the seal inside the pump may be worn or damaged. Continued operation of the pumpisnot recommended.Furtherusageofthe pumpunder theseconditionsmaycauseseverewaterdamagetoengine.

Hoses and Clamps

1.Check that all hoses are securely attached to the pump. Make certain suction hose (Figure 2) does not have any air leakage.Tighten hose clamps and couplings as required.

2.Itisrecommendedthat 2 clampsbeusedwhensecuringthe suction hose to the inlet side (suction) of the pump.

3.Remember suction hoses must be rigid enough not to collapse when the pump is in operation.

4.Check that the discharge hose (Figure 2) is not restricted. Place hose so that it lays as straight as it is possible on the ground. Remove any twists or sharp bends from hose which may block the flow of water.

QP-301TH — PRE-SETUP (PUMP)

Suction and discharge hoses are

NOTE available from Multiquip. Contact your nearest dealer for more information.

5.The discharge hose is usually a collapsible (thin-walled) hose, however if a thin-walled discharge hose is not avail- able, a rigid suction hose can be substituted in its place.

6.Make sure the suction strainer (Figure 2) is clean and securely attached to the water end of the suction hose. The strainer is designed to protect the pump by preventing large objects from being pulled into the pump.

CAUTION :

The strainer should be positioned so it will remain completely under water. Running the pump with the strainer above water for long periods can damage the pump.

CAUTION :

DO NOT pump flammable fluids, corrosive chemicals or fluids containing toxic substances. These fluids can create potentially dangerous health and environmental hazards. Contact local authorities for assistance.

CAUTION :

This pump uses a water-cooled mechanical seal to prevent water from seeping into the engine. The passage of water through the pump casing lubricates the seal and prevents it from overheating. NEVER! operate the pump without water in the casing as this will cause damage to the mechanical seal.

PAGE 16 — QP-301TH TRASH PUMP — PARTS MANUAL — REV. #4 (10/05/05)

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Multiquip Model QP-301TH Gasoline Powered Trash Pump 2 QP-301TH Trash Pump Parts Manual REV. #4 10/05/05 Heres HOW to GET Help QP-301TH Table of Contents Parts Ordering Procedures When ordering parts Please supply the following informationQP-202TH Safety Message Alert Symbols Accidental Starting General Safety Rules for Safe OperationRules for Safe Operation Specifications Pump Specifications Engine QP-301TH General Information ApplicationQP-301TH Pump Components QP-301TH Basic Engine Initial ServicingQP-301TH PRE-INSPECTION Engine QP-301TH PRE-SETUP Pump Read safety instructions at the beginning of manualQP-301TH Initial START-UP Engine QP-301TH Initial START-UP Engine QP-301TH Trash Pump Parts MANUAL- REV 10/05/05 QP-301TH Maintenance Pump Pump Vacuum TestQP-301TH Maintenance Pump QP-301TH Maintenance Engine Engine Maintenance ScheduleQP-301TH Maintenance Engine QP-301TH Preparation for Long -TERM Storage Pump StorageQP-301TH Trash Pump Parts MANUAL- REV 10/05/05 QP-301TH Troubleshooting Engine Engine TroubleshootingQP-301TH Troubleshooting ENGINE/PUMP QP-301TH Explanation of Code in Remarks Column Items Found In the Items Number ColumnQP-301TH Suggested Spare Parts QP-301THTRASH PUMP1TO 3 Units Honda GX240K1PA2 EngineQP-301TH Pump Assy Pump AssyENGINE, Honda Casing NPS3Casing Cover Suction Cover NPS332 QP-301TH Trash Pump Parts Manual REV. #4 10/05/05 Bolt Engine M10 X Bolt Casing Cover M8 XWasher M10 Seal Washer M8Honda GX240K1PA2 Engine AIR Cleaner Assy AIR Cleaner AssyCOVER, AIR Cleaner GROMMET, AIR CleanerCOLLAR, AIR Cleaner Collar B, AIR CleanerHonda GX240K1PA2 Engine Camshaft Assy Camshaft AssySPRING, Weight Return ARM, Valve RockerLIFTER, Valve PIVOT, Rocker ARMHonda GX240K1PA2 Engine Carburetor Assy Carburetor AssyGasket SET Valve SET, Float Float SET Engine S/N BE70B aScrew SET, Drain Screw SET B Choke SET Includes Items W SCREW, Throttle Stop NOZZLE, Main Collar SETHonda GX240K1PA2 Engine Control Assy Control AssySPRING, Control Adjusting ARM, GovernorROD, Governor SPRING, GovernorHonda GX240K1PA2 Engine Crankcase Cover Assy Crankcase Cover AssyWEIGHT, Governor HOLDER, Governor WeightPIN, Governor Weight GASKET, Case CoverCrankshaft /BALANCER Weight Assy Honda GX240K1PA2 Engine CRANKSHAFT/BALANCER AssyWEIGHT, Balancer Honda GX240K1PA2 Engine CRANKSHAFT/BALANCER AssyHonda GX240K1PA2 Engine Cylinder Barrel Assy Cylinder Barrel AssySHAFT, Governor ARM BOLT, Drain PLUG2Washer NUT, Flange 10MMHonda GX240K1PA2 Engine Cylinder Head Assy Cylinder Head AssyGUIDE, Valve OS Optional CLIP, Valve GuideGASKET, Cylinder Head COVER, HeadHonda GX240K1PA2 Engine FAN Cover Assy FAN Cover AssyCLIP, Wire Harness CLIP, TubeShroud SUB- HarnessHonda GX240K1PA2 Engine Flywheel Assy Flywheel AssyFAN, Cooling FlywheelHonda GX240K1PA2 Engine Fueltank Assy Fuel Tank AssyRUBBER, Supporter 107MM JOINT, Fuel TankTANK, Fuel *NH1* Black GASKET, Fuel Filler CAPHonda GX240K1PA2 Engine Ignition Coil Assy Ignition Coil AssyGROMMET, Wire Coil ASSEMBLY, IgnitionWIRE, Stop Switch 370MM Honda GX240K1PA2 Engine Muffler Assy Muffler AssyMuffler PROTECTOR, MufflerPROTECTOR, Exhaust Pipe PIPE, ExhaustHonda GX240K1PA2 Engine Piston Assy Piston AssyBOLT, Connecting ROD Ring SET, Piston StandardRing SET, Piston OS0.25 Ring SET, Piston OS.50Honda GX240K1PA2 Engine Recoil Starter Assy Recoil Starter AssyPULLEY, Recoil Starter RACHET, StarterSPRING, Friction SPRING, Starter Return64 QP-301TH Trash Pump Parts Manual REV. #4 10/05/05 Gasket KIT Assy Honda GX240K1PA2 Engine Gasket KIT AssyGASKET, CYL. Head Cover Honda GX240K1PA2 Engine Labels Assy Abels AssyEmblem Internal MARK, Caution ExternalLABEL, Caution MARK, Choke ExternalEffective October 1, 2002 Terms and Conditions of Sale Parts QP-301TH Trash Pump Parts MANUAL- REV 10/05/05 Multiquip INC

QP-301TH specifications

The Multiquip QP-301TH is a state-of-the-art portable generator designed to meet the diverse power needs of contractors, professionals, and outdoor enthusiasts. Known for its durability, performance, and reliability, this model is a popular choice in the generator market, especially among those requiring consistent and efficient power supply.

One of the main features of the QP-301TH is its robust engine. It is powered by a reliable Honda GX390 engine known for its fuel efficiency and low emissions. This engine offers a starting wattage of 3000 watts and a running wattage of 2400 watts, which is ideal for powering tools, small appliances, and equipment. The generator’s design allows for 120-volt output, providing versatility for various applications.

The QP-301TH also boasts a user-friendly control panel that simplifies the operation. It includes clearly labeled outlets, such as two 120V GFCI outlets and one 120V twist-lock outlet, ensuring easy connectivity to electrical devices. The generator is equipped with an electric start system, facilitating effortless ignition, which is particularly helpful in emergency situations or when the generator is needed quickly.

Portability and convenience are key characteristics of the QP-301TH. Weighing approximately 190 pounds, it features built-in wheels and a comfortable handle that make transport and maneuvering straightforward, making it a practical choice for job sites, camping, or tailgating.

Moreover, the generator incorporates several advanced technologies to enhance performance and safety. The low-noise operation, a hallmark of Multiquip generators, ensures a quieter working environment, while the automatic shut-off feature protects the engine from damage in case of low oil levels.

The protective frame provides durability and safeguards the generator against accidental impacts. It is also designed to withstand various weather conditions, making it suitable for outdoor use.

Overall, the Multiquip QP-301TH stands out due to its combination of power, efficiency, and portability. Its user-centric design and advanced safety features make it a desirable choice for those looking for a dependable generator to handle their energy needs. Whether for professional use or recreational activities, the QP-301TH is a reliable power solution.
Top Page Image Contents