Multiquip GB12BP, GB12BW, GB12BS manual Storage, Lowering the Mast

operation (gb12bw)

Storage

1.Loosen the lower T-handle by turning handle counterclockwise (Figure 20). Push down on mast until mast is fully inserted into mast housing. Tighten T-handle fully.

PROTECTIVE

COVER

AC-POWER

VELCRO

TAB

CABLE

LOWER

T-HANDLE

Figure 20. Lowering the Mast

2.Unzip the zipper on the protective cover (Figure 20), and pull down cover over balloon/lamp assembly.

ZIPPER

PROTECTIVE

COVER

Figure 21. Unzipping the Protective Cover

3.Unhook lamp AC power cable from washer eyelet (Figure 14). Fully zip protective cover and fold velcro tab in place (Figure 22).

Figure 22. Zipping the Protective Cover

4.Loosen upper T-handle by turning counterclockwise and lift lamp assembly from mast.

5.Store lamp assembly enclosed with its protective cover (Figure 23) in a safe location where it will not be damaged.

PROTECTIVE

COVER

Figure 23. Storing Lamp Assembly

6.To retract tripod legs (Figure 24) and place in the stow position, lift up on mast while pulling up on the velcro strap. Continue pulling upward on the mast until the tripod legs are fully retracted and are in the stow position.

LATCH

MAST

UPPER

LOWER

Figure 24. Retracting Tripod Legs

page 22 —gb12bw/bs/bp LIGHTING SYSTEM • operation and parts manual — rev. #0 (06/24/13)