Multiquip GB12BS, GB12BP manual Raising the Mast GB12BW, Sand Bags

setup (gb12bw)

Raising the Mast (GB12BW)

1.Before raising the mast, make sure the upper T-handle bolt lock (Figure 15) is securely tightened. This will prevent the balloon/lamp assembly from falling off. In addition make sure that the lamp power cable is connected to the mating end of the 15 ft (4.5 meters) power source cable.

DANGER

ALWAYS make sure the area above the lighting system is open and clear of overhead power lines and other obstructions. The mast extends in excess of 13 ft. (4 meters) when an optional extension is used. Contact with overhead power lines or other obstructions could result in equipment damage, serious Injury or death!

2.To improve stability and to prevent tipping of the light unit, place sand bags or similar type weight over the tripod legs or weight hook as shown in Figure 15.

UPPER

T-HANDLE

MAST

RAISE LOWER

T-HANDLE

WEIGHT

HOOK

SAND

BAGS

CAUTION

When raising mast, ALWAYS be on the lookout for overhead obstructions such as high voltage power lines. The possibility exists of electrocution, even death! if the lighting system comes in contact with high voltage power lines.

DANGER

When raising mast, ALWAYS be on the lookout for overhead obstructions such as high voltage power lines. The possibility exists of electrocution, even death! if the lighting system comes in contact with high voltage power lines.

Figure 15. Sand Bags

3.Raise mast to desired height and tighten lower T-handle (Figure 15) securely.

page 20 —gb12bw/bs/bp LIGHTING SYSTEM • operation and parts manual — rev. #0 (06/24/13)