The oven light is a standard
To Replace:
1.Unplug range or disconnect power.
OvenLight
2.Turn the glass bulb cover in the back of the oven counterclockwise to remove.
3.Turn bulb counterclockwise to remove from socket.
4.Replace bulb, then bulb cover by turning clockwise.
5.Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.whirlpool.com
Operation
PROBLEM | POSSIBLE CAUSES | SOLUTIONS |
Nothing will operate | Power supply cord is unplugged. | Plug into a grounded outlet. |
|
|
|
| Household fuse is blown or a | Replace the fuse or reset the circuit breaker. If the problem |
| circuit breaker is tripped. | continues, call an electrician. |
|
|
|
| Range is in Sabbath Mode. | See “Sabbath Mode” section. |
|
|
|
Cooktop will not operate | The control knob is set | Push in knob before turning to a setting. |
| incorrectly. |
|
The range is in Demo Mode.
Demo Mode will deactivate the Warm Zone element. See “Demo Mode” in the “Electronic Oven Controls” section.
Excessive heat around | Cookware that is not the proper |
cookware on cooktop | size |
Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.
Cooktop cooking results not | Control knob set to incorrect heat | See “Cooktop Use” section. |
what expected | level |
|
|
|
|
| Range is not level. | Level the range. See the Installation Instructions. |
|
|
|
Oven will not operate | The electronic oven control was | See “Electronic Oven Controls” section. |
| set incorrectly. |
|
|
|
|
| Delay Start was set. | See “Cook Time” section. |
|
|
|
| The oven control lockout is set. | See the control lock keypad feature in the “Feature Guide” |
|
| section. |
The range is in Demo Mode.
Demo Mode will deactivate all heating elements. See “Demo Mode” in the “Electronic Oven Controls” section.
Convection fan not working | Oven door is open. | Close oven door. See “Convection Cooking” section. |
|
|
|
Oven temperature too high or | Oven temperature calibration | See “Oven Temperature Control” in the “Electronic Oven |
too low | needs adjustment | Controls” section. |
|
|
|
| Temperature has been changed | See “Fahrenheit and Celsius” in the “Electronic Oven Controls” |
| to Fahrenheit or Celsius. | section. |
|
|
|
Oven indicator lights flash | Needs service (oven indicator | See “Control Display” in the “Electronic Oven Controls” |
| lights are flashing) | section. If the indicator light(s) keeps flashing, call for service. |
|
| See cover for contact information. |
|
|
|
Display shows messages | Power failure (display shows | Clear the display. On some models, reset the clock, if needed. |
| flashing time) | See “Clock” keypad feature in the “Feature Guide” section. |
|
|
|
| Error code (display shows letter | Press the CANCEL keypad to clear the display. See “Control |
| followed by number) | Display” in the “Electronic Oven Controls” section. If it |
|
| reappears, call for service. See cover for contact information. |
16
