Minelab x-terra manual 10 cm

Page 52

52

4” (10 cm)

If ground balance is in between two numbers, select the lowest number.

Using the detector in all metal, ﬁnd a clear area of ground without any targets.

Hold the coil parallel and 4” (10 cm) above the ground. Select GROUND BALANCE*. A constant hum known as the ground balance tone will sound when the coil is held steady.

Continuously lower and raise the coil towards and away from the ground and listen to the ground balance tone. Try to lower the coil as close to the ground as possible without touching it.

Adjust the ground balance using + and -, listening for minimum volume which will occur during the transition from low to high.

If the tone is low, increase the ground balance setting using +, if the tone is high, decrease the setting using -. The menu scale and numeric ID will indicate the chosen setting.

Image 52

Contents Page Connecting the Coil Holding the DetectorSweeping the Coil Discrimination ScaleVolume Detailed Detector OperationControl Box Coil Page Page Page Attach the middle shaft to the upper shaft in the same way Holding the Detector, pg Connecting Page Close the battery door by pushing and sliding it downwards Behaviour, pgCongratulations Thread your arm through the armrest Shaft is too short 5cm Coil parallel to the ground Adjustment to compensate for diﬀerent types of soil Liquid Crystal Display LCD area If the detector emits an overload sound There are many metallic objects insideOverloading is not harmful to the detectors electronics Page Is passed over a target Rusted nail, pull-tab, brass button and aluminium foilGround, there may be unknown buried metal objects X-Terra coil is waterproof. Care of Your X-Terra, pg Medium High Discrimination PatternNon-ferrous coin Low Ferrous nail Page Target ID Numeric identiﬁerPage X-Terra 30 has 12 segments X-Terra 50 has 18 segmentsExample targets only No target signals are rejected Accepts signals from non-ferrous targetsAll Metal Pattern PatternAll metal pattern cannot be edited 2AL High This target will LowPage Ask for permission before searching on private property Page Page All Metal Depth IndicatorPatterns Menu Menu scalePinpoint Indicates that pinpoint is activatedHeadphones BatteryReject Identiﬁcation Settings DetectionTarget ID Discriminated Detected Rejected accepted Segment segmentDetection Settings Terra Factory preset =15-20 = X-Terra Page Terra Volume range = Page Page Page Ground balance range = Factory preset = Page 10 cm Low High Medium Quiet Press Accept Reject to reject that target ID Method 2 to reject a speciﬁc target ID using + All metal pattern cannot be editedPress and hold Press once During the start up sequence Patterns Erased / Factory Preset ErrorLow Battery Signal Low Battery ShutdownTarget Response Pinpoint ResponseNoise False DetectionsCoil Error Coil UnpluggedCoil Incompatible But the detector is not recognising itUse of headphones will increase battery life Black segments inside the outlineBlack segment inside the outline Icon will begin to ﬂash forAlkaline NiMH/NiCad Your X-Terra is common sense Page As soon as the headphones are connected Volume, pgAlways use headphones with a ¼ jack Connecting HeadphonesPlug the headphone jack into the socket Skid Plate Environmental CoverTo attach an accessory coil Turn the detector oﬀ using PowerSearch Mode Weight Excluding BatteriesOptional Accessories Transmission+ Power Standard 7.5 kHz+ All Metal 20, 24, 28, 32, 36, 40Page Page Available on X-Terra 50 model only Page World Leader in Metal Sensing Technology Working for a Cleaner Greener Future