Minelab SD2100v2 instruction manual Accessories, Search Coils

Page 27

Instruction Manual

Page 17

12. Accessories

Figure 9 - Coil Search Patterns

12.1Search Coils

The SD2100v2 is supplied with the 11” Double ‘D’ as its standard coil. Three other coils are available as accessories for use on the SD2100v2

— the 18”, 11”, and 8” Monoloop coils.

CAUTION

DO NOT PLUG ANY SD SERIES COILS INTO ANY OTHER

DETECTOR!

This action can damage other detectors and such damage is not

covered by warranty

Monoloop coils tend to give slightly stronger or more sensitive signals than the Double ‘D’ coil. However, Monoloop coils are also a little more ‘noisy’ if the ground is heavily mineralised.

Larger diameter coils tend to give better ground coverage and deeper depth than smaller coils. However, a smaller coil tends to have increased sensitivity to tiny targets than larger coils.

There is, therefore, a definite advantage and purpose for each of the range of coil types and sizes.

Image 27
Contents Minelab SD2100v2 Minelab Electronics Pty Limited Minelab SD2100v2 Table of ContentsIntroduction SD2100v2 List of Parts Part Item Number List of PartsUnpacking and Assembly SD2100v2 Battery Assembly Rear Panel Controls Control BoxFront Panel Controls Search SwitchQuick Start Instructions OperationSet the Threshold Control Operating InstructionsDetector Sounds Turning on the SD2100v2Ground Balancing Set the Tune ControlMinelab SD2100v2 Auxiliary Parts BatteryBattery Chargers Charging the BatteryVehicle Battery Charger Searching Detecting TechniquesProspecting Tips Identifying Target Signals Hints for Maximum Gold RecoveryPinpointing Pinpointing ProcedureDigging the Target Digging Deep Targets Salty EnvironmentsMaintenance Troubleshooting Specification Warranty Search Coils AccessoriesCorporate Clothing BatteriesPage Minelab SD2100v2 Page Minelab SD2100v2 Minelab Service Repair Form