Minelab instruction manual SD2100v2 Battery Assembly

Page 8

Page 8

The Minelab SD2100v2

j)Fit the battery (12) into the battery bag (13).

k)Plug the headphones (17) into the socket in the cap of the battery.

l)Put on the battery bag. Ensure that the Power switch on the control box is set to “Off”. Plug the connector on the battery cable into the power connector on the control box. This cable connects the battery to the detector.

Figure 2 - SD2100v2 Battery Assembly

Image 8

Contents Minelab SD2100v2 Minelab Electronics Pty Limited Table of Contents Minelab SD2100v2Introduction SD2100v2 List of Parts List of Parts Part Item NumberUnpacking and Assembly SD2100v2 Battery Assembly Control Box Rear Panel ControlsSearch Switch Front Panel ControlsOperation Quick Start InstructionsOperating Instructions Detector SoundsTurning on the SD2100v2 Set the Threshold ControlSet the Tune Control Ground BalancingMinelab SD2100v2 Battery Battery ChargersCharging the Battery Auxiliary PartsVehicle Battery Charger Detecting Techniques SearchingProspecting Tips Hints for Maximum Gold Recovery Identifying Target SignalsPinpointing Procedure PinpointingDigging the Target Salty Environments Digging Deep TargetsMaintenance Troubleshooting Specification Warranty Accessories Search CoilsBatteries Corporate ClothingPage Minelab SD2100v2 Page Minelab SD2100v2 Minelab Service Repair Form