Vector VEC095 Maintenance/Replacement, Battery, Simultaneous Recharge and Inverter Operation

Page 16

To check the battery status, press the Battery Status Display Push-button. If the Jump-StarterÕs battery is fully discharged, it is recommended that the host vehicle or boatÕs engine being used for recharging be left operating while the unit is being charged using the 12 Volt DC/DC method.

WARNING: DO NOT recharge main unit for more than 8 hours maximum using 12 Volt DC method. After charging, disconnect the cables and store them in the Cable Storage Area.

8.3Simultaneous Recharge and Inverter Operation

The inverter can be operated to power up to 80 watts during battery recharge. This will slow recharge, but ElectroMate can be used as a UPS system.

9 . Maintenance/Replacement

Parts

 

 

 

For replacement parts, cables, etc, contact Vector Technical Support: toll-free

(866)584-5504. ElectroMate is modular in construction. If the charger, lamp, compressor or inverter require service, unit should be returned to Vector. Note that the inverter can be shipped back mounted to the battery compartment cover. Periodically, the cables and connectors should be inspected for dam- age, corrosion, dust and dirt. If surfaces are dirty, they can be wiped clean with a cloth moistened with water and a small drop of detergent. Contacts can be wiped clean with a dry cloth.

WARNINGS: There are no user serviceable parts inside. Do not operate unit if there is any evidence of damage. The product must be returned to Vector for testing and repair. Replace any damaged cables immediately before further use.

1 0 . Battery

Disposal

 

 

 

Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is required. Contact your local authority for information. Failure to comply with local, state and federal regulations can result in fines or imprisonment. Sealed lead-acid battery must be recycled or disposed of properly.

Battery Disposal Warnings:

1.Do not dispose of the battery in fire as this may result in an explosion.

2.Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).

3.Do not expose battery to fire or intense heat as it may explode

16

Image 16
Contents Volt AC, 12 Volt DC Portable Power Supply VEC095Important Safety Instructions Jump-Start Warnings and CautionsN t e n t s ApplicationsN T R O D U C T I O N General Jump-Start Cables and Protection Additional Key Features ApplicationsUsing ElectroMate Jump-Start Jump-start ProcedureUSE Inverter OperationUse with Appliances Principles of OperationPlacement of ElectroMate Powering an AC LoadOperating Time Compressor/Tire Troubleshooting the InverterOperating Tips Compressor Safety Information Compressor UseInflation of tire or products with a valve stem Typical inflation timesRecharging FluorescentInflating Items Without a a Tire Stem AC Recharge DC RechargeMaintenance/Replacement BatteryBattery Disposal Warnings Simultaneous Recharge and Inverter OperationSpecification s Appendix a Battery InstallationAppendix B Appendix Battery InstallationExtending Operating Time Troubleshooting Appendix C SymptomYear Limited Warranty Registrationform