Marantz PM-15S1 manual Basic Operation, Disc Playback on an Super Audio CD Player

ENGLISH

BASIC OPERATION

PLAYBACK

To explain how to play back input sources, representative examples are given with an Super Audio CD player and analog record player. Before starting either procedure, check the component is correctly connected to the PM-15S1.

7Disc Playback on an Super Audio

CD Player

1.Press the power ON/OFF switch of the Super Audio CD player to activate power to it.

2.Press the POWER ON/OFF switch q of the PM-15S1 to activate power to it. Approximately 8 seconds after power has been activated, the muting turns OFF and audio output is enabled. When using multiple PM-15S1s connected by FCBS, turn power ON in the order of lowest to highest ID number, starting from ID 1.

3.Select the input source from the INPUT SELECTOR knob e on the PM-15S1 or the input selector buttons z of the remote controller.

4.To use the speakers connected to the SPEAKER SYSTEMS terminals, press the SPEAKERS button !0on the PM-15S1.

5.Load a disc into the Super Audio CD player and press the play button to start playback.

6.Adjust the volume level from the VOLUME knob r on the PM-15S1 or the VOLUME 3/4 buttons n of the remote controller.

7.Adjust bass/treble as desired from the BASS and TREBLE knobs t. Be sure to first set the TONE button o on the PM-15S1 or the TONE button v on the remote controller in the ON position.

8.You can turn the display and side illumination ON/OFF as suited for the room environment. Press the DISPLAY button i on the PM-15S1 or the DISPLAY button m of the remote controller.

7Disc Playback on an Analog

Record Player

1.Press the POWER ON/OFF switch q of the PM-15S1 to activate power to it. Approximately 8 seconds after power has been activated, the muting turns OFF and audio output is enabled. When using multiple PM-15S1s connected by FCBS, turn power ON in the order of lowest to highest ID number, starting from ID 1.

2.Select “PHONO” as the input source from the INPUT SELECTOR knob e on the PM-15S1 or the input selector buttons z of the remote controller. To prevent unexpected accidents, it is recommended to set the volume level to –∞(mute) by turning the VOLUME knob r until muting the volume level.

3.Set the PHONO MC button !3on the PM-15S1 to MC or MM according to the cartridge you are using.

4.To use the speakers connected to the SPEAKER SYSTEMS terminals, press the SPEAKERS button !0on the PM-15S1.

5.Set a record on the analog record player and play it.

6.Adjust the volume level from the VOLUME knob r on the PM-15S1 or the VOLUME 3/4 buttons n of the remote controller.

7.Adjust bass/treble as desired from the BASS and TREBLE knobs t. Be sure to first set the TONE button o on the PM-15S1 or the TONE button v on the remote controller in the ON position.

8.You can turn the display and side illumination ON/OFF as suited for the room environment. Press the DISPLAY button i on the PM-15S1 or the DISPLAY button m of the remote controller.

OPEN/		SOUND
CLOSE		MODE
PHONO	BALANCED	CD
RECORDER 1		LINE 1
RECORDER 2		LINE 2
TRIM	EXIT	TONE
	+
L		R
	ENTER
DISPLAY	-	ATT
VOLUME
RANDOM	SCAN	REPEAT
TOP MENU	RETURN	MENU
AM/A	FM/B
RC-11PMS1

14