Marantz PM6002 Stereo Amplifier Manual

ENGLISH

NAMES AND FUNCTIONS OF PARTS

REMOTE CONTROLLER	z POWER ON/STANDBY buttons

x Input selector buttons

c VOLUME adjustment buttons

Using this remote controller, you can control the PM6002 and Marantz CD players, DVD players, tuners, tape decks etc. that have a remote control receptor. The operations possible by remote controller may differ with each component; therefore see the instruction manual that came with the component.

a.MAIN POWER ON button

Turns the PM6002 power on when it is in the standby mode.

b.MAIN POWER STANDBY button

Sets the PM6002 power to the standby mode when it is set to the power-on mode.

c.SOURCE POWER button

• Input source Button

These buttons are for directly selecting the

input source. The AMP button is not used on

the PM6002.

Caution

In the PM6002, AUX and DVD, and RECORDER 2’s TAPE and MD each share the same input jacks. The signal codes for

•	MUTE Button
	This button activates the mute function.
	Pressing this button again releases the
	MUTE function.
	The MUTE function can also be released
	by pressing either the VOLUME 5 or ∞
	buttons.
•	VOLUME 5 Button

The remote controller buttons are laid out as shown below.

OPEN/		SOURCE	z
CLOSE		POWER	z
PHONO	CD	AMP
TUNER	AUX	DVD	x
RECODER1	RECODER 2
CD-R	TAPE	MD

INPUT	MUTE	VOLUME	c

Switching the mode of a CD player, tuner, CD-R or other Marantz component equipped with a power standby function between power-on and standby is enabled by pressing this button after the FUNCTION SELECT button corresponding to the component has been pressed.

When this button is pressed after pressing the TUNER button, the tuner’s power is turned on; when it is pressed again, the tuner is set to the standby mode.

When this button is pressed after pressing the AMP button, the PM6002 is switched from the power-on mode to the standby mode or vice versa.

*The remote controller cannot be used to turn the primary power of the amplifier ON and OFF.

controlling these Marantz products using the RC002PM differ, therefore separate buttons have been built into the remote controller.

•INPUT % Button

This button is for forward-feeding the input source indications to select a desired source.

The input source indication, which is displayed on the function indicator on the main frame, is fed to the right.

•INPUT ﬁ Button

This button is for backward-feeding the input source indications to select a desired source.

The input source indication, which is displayed on the function indicator on the main frame, is fed to the left.

This button increases the volume level.

• VOLUME ∞ Button

This button decreases the volume level.

vComponent operating buttons

These buttons are for performing basic operations of a Marantz CD player, DVD player, etc. The function of each button changes to match the component selected as the input source using the input selector buttons.

REPEAT

	ENTER
TOP MENU	MODE	MENU

RANDOM SCAN PROG. CANCEL