Marantz PM6002 manual Connections Wiring Speaker Cable, Connection of Speaker Systems

CONNECTIONS

WIRING SPEAKER CABLE CONNECTION OF SPEAKER SYSTEMS

ENGLISH

•Be careful not to short circuit in wiring speaker cables.

•Peel off the corting of speaker cable as shown below.

Approx. 1 cm

Cut the corting of	Peel off the edge Twist conductors.
cable.	of cable.

This unit is equipped with two sets of SPEAKER SYSTEM terminals––SYSTEM 1 terminals and SYSTEM 2 terminals. Usually connect your speaker system to the SYSTEM 1 terminals.

•The speakers in the speaker system should have an impedance between 8 and 16 ohms. If speakers with an impedance of less than 8 ohms are connected, the protection circuitry may be activated during play.

•Connect the Right channel speaker to the R terminals, and the Left channel speaker to the L terminals.

•The output terminals have positive (+: Red) and negative

(–: Black) polarity, and each speaker also has the same polarity (+ and –). When connecting the speaker, be sure to connect the terminals with the same polarity (+ with +, – with –).

• Wiring with speaker cable.

Turn counter-	Insert conductor	Turn clockwise to
clockwise to	of cable.	tighten.
loosen.

Your speaker system must satisfy the below conditions. If it does not, the PM6002’s protective circuit will active, whereby preventing proper playback. In some cases, the amplifier and speakers may be damaged.

• If using 1 set of speakers, total speaker

impedance must be 4 ohms or more.

GND	SPEAKER SYSTEMS
	SYSTEM	1	:	4 –16	OHMS
	SYSTEM	2	:	4 –16	OHMS
	SYSTEM	1+ 2 :		8 –16	OHMS

SYSTEM2

R L

PHONO TUNER CD AUX/DVD RECORDER 2	RECORDER 1
(MD / TAPE)	(CD-R)
L	L
R	R

• If using 2 sets of speakers, total speaker

impedance must be 8 ohms or more.

IN OUT IN OUT

R L

SYSTEM1

9