Land Pride 4210 installation instructions CVT Inner Enclosure Installation

Page 4

Land Pride

Assembly Instructions

CVT Inner Enclosure Installation

Refer to Figure 4:

1. Loosen engine mounting hardware.

NOTE: Clutch alignment tool (P/N 790-001A) may be purchased from your nearest Land Pride Dealer.

2.Use clutch alignment tool to adjust engine shaft shoulder to offset 1.937" (1 15/16") out farther than trans-axle shaft shoulder. Add shims as needed to finalize offset distance.

3.Make a dry run by installing pulleys and belt with no keys or shims.

a.Mount drive pulley (#17) onto the engine drive shaft.

b.Hang belt (#16) on drive pulley (#17).

c.Install belt (#16) on driven pulley (#18) and slide pulley onto trans-axle driven shaft.

d.Push both pulleys with installed belt back until they stop. Check belt alignment to make sure it is straight and aligned.

e.Add or remove shims from engine shaft if required.

NOTE: A thin layer of silicon can be added to the gasket to hold it against the engine block and in alignment with mounting holes.

4.Install gasket (#15) over engine drive shaft. Make certain gasket holes are in alignment with mounting holes on engine block.

5.Place CVT inner enclosure (#2) over trans-axle driven shaft and engine driven shaft.

6.Secure enclosure to engine block with four 5/16" x 1 1/4" hex socket screws (#5) with loctite applied to threads. Draw hex socket screws up snug; do not tighten.

IMPORTANT: Neoprene on washers (#14) in step 7 is placed against the inner enclosure.

7.Secure CVT inner enclosure to trans-axle shaft with four 5/16"-18 x 1" GR5 hex bolts (#7), neoprene plated washers (#14) and hex lock nuts (#9). Draw nuts up snug; do not tighten.

8.Center CVT inner enclosure over trans-axle driven shaft. Make sure enclosure clears axle shaft and tighten lock nuts (#9) to 17 ft.lbs. of torque.

9.Tighten hex socket screws (#5) to 20 to 25 in-lbs. of torque.

Inner CVT Shield, Pulleys & Belt Installation

Figure 4

4

Manual No. 700-520M

â–  3/20/07

Image 4
Contents Treker 4210/4410 ST Series Manual Part NumbersTools required Initial PreparationsLeft Side Panel Detachment Removal of Exhaust Heat ShieldRemoval of Air Hoses & Outer Enclosure Refer to FigureRemoval of Pulleys & Inner Enclosure CVT Inner Enclosure Installation Assembly of CVT Pulley and Belt Assembly of CVT Outer EnclosureAssembly of CVT Venting Final AssemblyKit No -519A Treker CVT/Cover Kit