Front Roller, Tractor Hook-Up | Land Pride FDR2572, FDR2584 specification

Table of Contents

Section 1: Assembly and Set-Up

Land Pride

Front Roller

Refer to Figure 1-3:

1.Remove the front two 1/2”-13 x 1 1/2” GR5 hex flange serrated screws (#9) and reinsert from the bottom as shown. Secure with existing 1/2” whiz nuts (#10).

Tighten nuts to 76 ft-lbs of torque.

2.Assemble brackets (#2) and (#3) to deck with carriage bolts (#4) and flange nuts (#5).

3.Insert roller (#8) between brackets and install pin (#1) through brackets and roller. Secure with washer

(#6) and cotter pin (#7).

Tractor Hook-Up

1.Be certain that tractor draw bar will not interfere. Move draw bar ahead or remove if required. Draw bar should also be checked for clearance when unit is being raised for the first time.

2.Align lower link arms of tractor to hitch clevises on mower. Insert lower hitch pins into lower ball swivels and attach linch pins.

3.Attach tractor top link to upper floating hitch on mower with pin supplied. Secure with lock pin.

4.Adjust the tractor top link in or out to place the upper hitch pin vertically above the lower hitch pins as shown in Figure 1-4, to allow mower flotation.

17366

Tractor Hook-Up

Figure 1-4

17713

Front Roller Assembly

Figure 1-3

10 FDR2572 & FDR2584 Grooming Mowers 310-262M

10/15/07