Land Pride FDR2584, FDR2572 manual Required, Gearbox Type, Bearing in Blade Spindle Hubs

Page 23

Land Pride

Table of Contents

Section 4: Maintenance and Lubrication

DO NOT

OVERFILL!

16648

Type 1

DO NOT

OVERFILL!

23582

Type 2

As

Required

IMPORTANT: Do not overfill! Level mower and wait for gearbox oil to cool before checking. A mower that is not level or a gearbox with hot oil will not show correct oil level on the dipstick.

Gearbox (Type 1)

Type of Lubrication: Gear Lube EP 80-90W

Check the oil level in the gearbox by either removing the dipstick on top of the gearbox or by removing the bottom plug at the rear of the box on the right hand side. Add oil if necessary by removing the top dipstick.

Do not overfill! Should your gearbox require service, take it to your Land Pride dealer.

Gearbox (Type 2)

Unscrew top vent plug in gearbox to remove dipstick. Wipe oil from dipstick and screw it back in without tightening. Unscrew dipstick and check oil level mark. If low, fill through top plug hole in gearbox with EP 80-90W oil until oil reaches full mark on the dipstick. Reinstall vent plug with dipstick and tighten.

Take your gearbox to a Land Pride dealer if it requires service.

Type of Lubrication: Gear Lube EP 80-90W

Quantity = Fill until oil reaches full mark on dipstick.

IMPORTANT: The Type 2 gear box is shipped with the gearbox vent plug and dipstick packaged in the Operator’s Manual bag and should have been installed in the gearbox by your Land Pride dealer. Please see your Land Pride dealer if the vent plug with dipstick was not included.

 

 

25

 

 

 

Hours

 

Bearing in Blade Spindle Hubs

 

 

 

Type of Lubrication: Multi-purpose Grease

 

 

17358

 

 

 

10/15/07

FDR2572 & FDR2584 Grooming Mowers

310-262M

21

Image 23
Contents Grooming Mowers Table of Contents Safety at All Times Tractors With Cabs Tractors Equipped With Practice Safe MaintenanceTransport Machinery Safely Keep Riders Off Machinery Tire SafetyWear Protective Equipment 818-540C 818-130C818-230C 818-543C 818-552C 818-558C 838-116C 818-555C 818-556C 838-270CIntroduction Using This ManualApplication Owner AssistanceDealer Preparations Preparation ChecklistVent Plug Installation Assembly and Set-UpFrame Tractor Hook-Up Front RollerChecking Driveline Minimum Length Driveline Installation12 FDR2572 & FDR2584 Grooming Mowers 310-262M Transporting Tractor Shut Down ProcedureOperating Checklist Operation CheckUn-hooking the Mower Mowing InstructionsGeneral Operating Instructions Leveling the Mower Cutting Height AdjustmentPoint Hitch Adjustments AdjustmentsBlade Inspection MaintenanceService Mowing Blades Maintenance and LubricationBlade Sharpening or Replacement Belt InstallationDriveline Storage StorageLand Pride Touch-up Paint Hours LubricationBearing in Blade Spindle Hubs RequiredGearbox Type FDR25 Rear Discharge Series Specifications & CapacitiesFDR25 Series Rear Discharge Mowers Features and BenefitsProblem Solution Rear discharge area plugged TroubleshootingIn-tpi1 Ft-lb3 · m · m ft-lb Torque Values Chart for Common Bolt SizesAppendix 26 FDR2572 & FDR2584 Grooming Mowers 310-262M Warranty Corporate Office P.O. Box Salina, Kansas 67402-5060 USA