Wiring Harness Update Kit
Assembly Instructions
| Razor Series ZR44 & ZR52 |
| Manual No. | ||
|
|
|
|
|
|
| Before You Start |
| Instructions For Kit No | ||
|
|
|
|
|
|
|
|
|
|
|
|
When you see this symbol, the subsequent
!instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it!
These instructions contain only information required to assemble the Wiring Harness Kit to the Razor Series ZR44 & ZR52 Riding Mowers. A detailed Operator’s Manual was supplied with the Razor. Refer to the Operator’s Manual for additional specific information especially information relating to safety concerns. Also included in the Operator’s Manual is important information on operation, adjustment, troubleshooting, and maintenance for this attachment (some manual sections do not apply to all options).
A separate Parts Manual for replacement parts can be purchased from your dealer or available free of charge at www.landpride.com. Have model and serial numbers handy when placing an order.
Manual Part Numbers:
•Operator’s
•Parts Manual . . . . . . . . . . . . . . . . . . . . . . .
General Information
Some ZR44 & ZR52 Razors may be experiencing a small drain on the battery when units are parked and the ignition off. Over time this small electrical drain can deplete the battery to a point that it fails to start the mower. If a unit is experiencing a repeated battery discharge for no obvious reason, installation of this simple kit will eliminate that condition.
These assembly instructions apply to the Razor ZR44 and ZR52 Kit Number:
Tools required:
•Electrical Tape
•Wire Cutters
•Wire Stripper
•Electrical Wire Crimpers
•Two 10 mm Metric Wrenches
•Terminal Removal Tool or
a Small Thin Bladed Screw Driver
A detailed listing of parts for wiring harness update kit No.
1.Park mower on a flat surface and move control levers to park.
2.Turn off engine and remove ignition key.
3.Raise seat deck fully up.
Refer to Figure 1:
4.Disconnect negative ground wire (black wire) from the battery’s negative post ( - ). Place ground wire in a location where it cannot touch the battery posts.
Negative |
Ground |
Negative Post
23811
Remove Ground Battery Connection
Figure 1
Refer to Figure 2:
5.Check battery drain with an amp meter by placing black probe on the negative battery post and red probe on the ground wire as shown. A drain of 7 milliamps or more is an indication that it would be helpful to install this wiring harness kit.
23812
7 milliamps 
or greater
Red Probe |
Black Probe
Negative Post
Ground wire
Battery Drain Check
Figure 2
© Copyright 2005 Pr inted | 1/16/07 ■ | Manual No. | 1 |