Marantz SR8200 manual Activating the RC3200A, Operating Devices, REMOTE-CONTROLLABLE Range

ENGLISH

ACTIVATING THE RC3200A

When the RC3200A is switched on for the first time or when it is reset, the Introduction screen appears for a few seconds. The RC3200A then automatically switches to the HOME screen that displays all available devices on your RC3200A. You can return to this HOME screen from within other screens by pressing the HOME button. See “Activating the HOME screen” for more details.

TURNING ON THE DISPLAY AND THE BACKLIGHT

RC3200A’s display can be activated in two different ways: Tap the touch screen gently with your finger or a blunt, soft object like a pencil eraser.

The display is activated.

1. Press ˆ button on the left side of the RC3200A.

The display and the backlight are activated.

If the LCD touch screen stays blank or becomes black when turning on the display, read the next section “Changing the LCD Contrast” to adjust the contrast of the LCD touch screen.

Note :

•RC3200A has a timeout feature: the LCD touch screen and the backlight automatically turn off to save power.

•See “Adjusting the Settings” to adjust the timeout for the LCD and the backlight.

CHANGING THE LCD CONTRAST

OPERATING DEVICES

To operate devices on your RC3200A you have to switch to the HOME screen.

This screen displays the available devices like TV, VCR, DVD, Amp and so on.

ACTIVATING THE HOME SCREEN

Press the HOME button.

The HOME screen appears, showing the available devices in the RC3200A.

SELECTING A DEVICE ON THE HOME SCREEN

Tap the soft button of the device you want to operate.

The first page of the selected device appears. “Using the Page Up and Page Down Buttons” to go to another page of the device.

You operate devices using the buttons on your RC3200A:

•Soft buttons (touch screen buttons);

•Hard buttons.

USING THE SOFT BUTTONS

By tapping the soft buttons on the LCD touch screen you send IR commands to the device you have selected.

The name of the active device is indicated at the top of the touch screen.

Note

•You can operate the soft buttons in the same way you operate hard buttons on a conventional remote control. When you keep the soft button pressed instead of tapping it, RC3200A keeps sending the IR command.

1. Press and hold the Backlight button. The screen lights up.

2. While still holding the Backlight button, press the Page Up button once to increase the LCD contrast one level.

The LCD contrast is adjusted one level up. or press the Page Down button once to decrease the LCD contrast one level. The LCD contrast is adjusted one level down.

3. Release the Backlight button when the contrast is satisfactory. The LCD contrast can be adjusted 16 levels.

Note

•To adjust the contrast multiple levels, you have press the Page Up or Page Down button multiple times.

•When you press and hold the Page Up or Page Down button, the LCD contrast will only change one level.

THE BATTERY STATUS

The battery icon	indicates the status of your batteries.
When the battery status is low, the Low Battery icon		appears at
the top of the touch screen.

You can still operate your devices, but you cannot adjust the settings, learn commands or record macros anymore.

REMOTE-CONTROLLABLE RANGE

The distance between the transmitter of the remote control unit and the IR SENSOR of the SR8200 should be less than about 5 meters. If the transmitter is pointed to a direction other than the IR SENSOR or if there is an obstacle between them, remote control may not be possible.

SR8200

60°

Remote control unit (RC3200A)

12