| Operation of Remote Control | |
| 1. Remote control | |
ENGLISH | ||
be possible. | ||
| The distance between the transmitter of the remote control unit and the | |
| IR SENSOR of the AV Surround Stereo Receiver should be less than about | |
| 5 metres. If the transmitter is pointed to a direction other than the IR | |
| SENSOR or if there is an obstacle between them, remote control may not | |
| ||
| ||
| Receiver |
Approx. 5 m meters
60 | ° |
Remote control unit
2. Loading batteries
The life of the batteries used with the remote control unit is about one year with normal use.
qRemove the back cover.
wInsert batteries (AAA type ) with correct
(+) and
eClose until it clicks.
CARE AND MAINTENANCE
This section describes the care and maintenance tasks that must be performed to optimize the operation of your Marantz equipment.
CLEANING OF EQUIPMENT EXTERNAL SURFACES
The exterior finish of your unit will last indefinitely with proper care and cleaning. Never use scouring pads, steel wool, scouring powders or harsh chemical agents (e.g., lye solution), alcohol, thinners, benzine, insecticide or other volatile substances as these will mar the finish of the equipment. Likewise, never use cloths containing chemical substances. If the equip- ment gets dirty, wipe the external surfaces with a soft,
If the equipment becomes heavily soiled:
–dilute some washing up liquid in water, in a ratio of one part detergent to six parts water;
–dip a soft, lint free cloth in the solution and wring the cloth out until it is damp;
–wipe the equipment with the damp cloth
–dry the equipment by wiping it with a dry cloth.
REPAIRS
Only the most competent and qualified service technicians should be allowed to service your unit. Marantz and its factory trained warranty station personnel have the knowledge and special equipment needed for the repair and calibration of this precision instrument.
In the event of difficulty, call the proper
THE PROTECTION CIRCUIT
If the protection circuit does work, the unit will enter to standby mode and do not only working for 3 seconds.
GENERAL MALFUNCTION
If the equipment malfunctions, this may be because an electrostatic discharge or AC line interference has corrupted the information in the equipment memory circuits. Therefore:
–power switch turns OFF
–after waiting at least three minutes, power switch turns ON
–
Memory backup
•In case a power outage occurs or the power cord is accidentally unplugged, the unit is equipped with a backup function to prevent memory data such as the preset memory from being erased.
The memory functions are backed up for up to about 2 week.
12