Programming with the 4-DIGIT Code

⁄7CLEAR button

This button is used to cancel for certain memory or programming operations.

⁄8DIMMER button

When this button is pressed once, the display is dimmed.

When this button is pressed twice, the display is turned off and the “DISPLAY OFF” indicator lights up.

Press this button again to turn on the display again.

⁄9NIGHT button

Pressing this button prevents the Dolby Digital signal from playback at a loud voice. This function reduces the voice by 1/3 to 1/4 at maximum. Thus, it eliminates the occurrence of an abruptly loud voice at night. However, the function is valid only for the case when the Dolby Digital signal is entered into OPTICAL or COAXIAL and data to compress the voice exists in the signal to be played back.

¤0S- ( Source) DIRECT button

When this button is pressed, the tone control circuit is bypassed as well as Bass Management.

¤1SETUP / T.TONE button

Test tone function is used for adjusting the balance between the volume levels of speaker channels. Press AMP button and press this button to enter the test tone mode.

¤2OSD button

When this button is pressed, the current setting are displayed on the TV monitor.

¤3SLEEP (sleep timer) button

This button is used for setting the sleep timer. It can be operated the same way as the button in unit.

¤4TV VOLUME UP () /DOWN () buttons

These buttons increase or decrease TV’s volume.

	PROGRAMMING THE REMOTE CONTROLLER	ENGLISH
	The remote controller RC5200SR must be programmed to use the	ENGLISH

codes for your appliances of different brands. This is done by keying in a 4-digit code or by scanning the codes until the correct one is found. We recommend to using the 4-digit code. This mode is faster and more reliable. The code scanning method should be used only if you cannot find the code for one of your appliances. The codes are listed at the end of this book.

Important:

Use the remote control buttons for programming, not the buttons of the receiver or other appliances.

1.Press and hold down the function button c for the appliance which should be controlled and press SETUP ¤1until the indicator z blinks twice.

2.Press the 4-digit code for appliance (codetable at the end of this book)

3.When the procedure is successful, the indicator will blink twice.

Notes:

If the indicator did not blink twice, then repeat steps 1 through 2 and try entering the same code again.

SCANNING THE CODE TABLE

1.Switch on the appliance which should be controlled.

2.Press and hold down the function button c for appliance which should be controlled and press SETUP ¤1until the indicator z blinking twice.

3.Press the code 9 - 9 - 1. The indicator will blink twice.

4.Aim the remote control at the appliance and slowly alternate between pressing POWER x and the function button c for the appliance.

5.Stop when the appliance turns off.

6.Press SETUP ¤1once to lock in the code.

CHECKING THE CODE

1.Press and hold down the function button c for appliance which should be controlled and press SETUP ¤1until the indicator z blinking twice.

2.Press the code 9 - 9 - 0. The indicator will blink twice.

3.To view the code for first digit, press 1 once.

Wait 3 seconds, count the indicator blinks (e.g. 3 blinks = 3) and write down the number.

Note:

If a code digit is “0”, the indicator will not blink.

4.Repeat step 3 three more times for remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit.