Jonsered CS 2147 manual KEY to Symbols, Key to symbols

Page 2

KEY TO SYMBOLS

Key to symbols

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved protective helmet

•Approved hearing protection

•Protective goggles or a visor

This product is in accordance with applicable EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

If your machine bears this symbol it is equipped with carburettor heating.

2 – English

If your machine bears this symbol it is equipped with a catalytic converter.

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

Image 2

Contents Operator′s manual KEY to Symbols Key to symbolsContents Personal protective equipment Safety InstructionsMachine′s safety equipment Chain brake and hand guard Chain catcher Stop switchThrottle lock Right hand guardChecking the hand guard MufﬂerChecking brake band wear Throttle lock Checking the inertia brake releaseChecking the brake trigger Chain catcherGeneral rules Stop switchCutting equipment Vibration damping systemChain Cutting equipment designed to minimise kickbackBar Some terms that describe the bar and chainWith a badly sharpened chain Sharpening your chain and adjusting raker clearanceGeneral information on sharpening cutting teeth Tensioning the chain General advice on setting raker clearanceSetting the raker clearance Sharpening cutting teethFilling with chain oil Lubricating cutting equipmentChain oil Checking chain lubricationChecking wear on cutting equipment Lubricating the bar tip sprocketNeedle bearing lubrication Chain drive sprocketDo not let go of the handles How to avoid kickbackWhat is kickback? General safety precautions Fuel safety StartingTransport and storage Basic safety rulesGeneral working instructions Terms Basic cutting techniqueGeneral CuttingSafe distance Tree felling techniqueLimbing Felling directionDirectional cuts Clearing the trunk and preparing your retreatFelling Felling cutCutting the trunk into logs Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tensionWhat is WHAT? What is what on the chain saw?Fitting a spike bumper AssemblyFitting the bar and chain Working with the chainFollowing applies to chain saws with catalytic converters Fuel HandlingFuel Chain oil FuellingCold engine Starting and StoppingStarting and stopping Warm engineStopping Maintenance CarburettorStarter Fine adjustment of the idle speed TCorrectly adjusted carburettor High speed jet HTensioning the recoil spring Air ﬁlterSpark plug Changing a broken recoil springMufﬂer Adjustment of the oil pumpWhen making adjustments Needle bearing lubricationElectrical carburettor heating CS 2147WH, CS 2152WH Centrifugal cleaning TurboHeated handles CS 2147W, CS 2152W Winter useMonthly maintenance Daily maintenanceWeekly maintenance Below you will ﬁnd some general maintenance instructionsTechnical Data Technical dataBar and chain combinations Cispr 121997, EN608 EC-declaration of conformityApplies to Europe only Page 1088890-26