Air, Frequency, Maximum & Minimum Peaks

J-Sha II Owner's Manual

WHIRLPOOL OPERATION

ROLLING WAVE BUTTON & LED MAXIMUM PEAK BUTTONS & LED

ON/OFF BUTTON & LED

BODY JETS BUTTON & LED

AIR INCREASE

&DECREASE BUTTONS & LED

OFF

MIX

			TONIC
			RELAX
+			80-130
_			110-150
_			130-220
+	0	_	TIME	25
_		_		+
_				+
+		_SPEED		+
_				+
_
		_INTENSITY
				+

TIME BUTTON & LED SCALE

MINIMUM PEAK BUTTON & LED

INTENSITY BUTTON & LED SCALE

SQUARE WAVE BUTTON & LED

FREQUECY BUTTONS & LED

WHIRLPOOL

Press BODY JETS button:

The body jets led will come on while the TONIC indi- cator, 110-150 LED and the SPEED scale will all turn off. The value on the TIME and INTENSITY scales will change to preprogrammed values. The duration of this cycle is about 20 minutes. The intensity of the jets are held constant and the air is off.

VARIATIONS FROM DEFAULT SETTINGS

TIME or INTENSITY:

Repeatedly press + or - buttons for each function. Variations from the preprogrammed values are dis- played by the relative LED scales.

AIR:

The default for body jets is air off. Press the upper AIR button to turn on the air flow. The LED turns on. Press the upper button to increase the air flow from the body jets. Press the lower air flow to decreases air flow. When the LED goes off, the air is off.

For pulsating air flow, press and hold the upper or lower air button twice. The LED flashes to indicate this mode. To turn off press either button once again.

ROLLING function:

Press the ROLLING button. The LED comes on. In this cycle the intensity of the jets is gently modulated with repeated pulses. The cycle starts with a mini- mum intensity to a maximum intensity with an imme- diate drop off toward the minimum. Press again to return to continuous flow operation.

SQUARE function:

Press the SQUARE button. The LED comes on. In this cycle the intensity of the jets is energetically modu- lated with short repeated pulses. The maximum peak will last for an interval then drop off to the minimum. Press again to return to continuous flow operation.

FREQUENCY:

The speed of the whirlpool jet action can be increased or decreased by the use of these buttons. Press + or

-buttons to increase or decrease the frequency of either the rolling or square pulses. The LED comes on.

MAXIMUM & MINIMUM PEAKS:

The whirlpool jet action can be made more or less gentle, or more or less forceful by use of these but- tons. Press + or - buttons to increase or decrease the maximum or minimum peaks of either the rolling or square pulses. The LEDs comes on.