4 INSTALLATION
4.4Plumbing Installation
DANGER - RISK OF SCALDING
The hot water supply to the tub MUST NOT exceed 110° F (43° C) to protect the user from scalding.
WARNINGS
Be certain all plumbing work is performed by a qualified plumber and is in compliance with local codes.
Some state and local plumbing codes require the installation of a “reduced pressure zone” (RPZ) assembly on both the incoming hot and cold supply lines to prevent back flow contamination into the potable water system. Invacare recommends you check local plumbing code requirements to determine if RPZs are required on your tub installation. RPZs are NOT supplied by Invacare and are to be provided by the customer if required.
CAUTIONS
Purge water lines. Hot and cold lines MUST be purged (blown down) to clear lines of debris prior to connection. Valves and spray heads may become inoperable and/or damaged if lines are not properly cleared. Items damaged in this way are not covered under the warranty.
When operating water pressure exceeds 55 PSI, pressure regulators (similar to the
1.Refer to Electrical and Plumbing
2.Measure the location of the drain on the unit.
3.Install the drain in the floor in the appropriate location determined in STEP 2.
4.Purge water lines. Hot and cold lines MUST be purged (blown down) prior to connection, to clear lines of debris.
5.Install On/Off valves at wall and use unions between valves and stubs.
6.Connect hot and cold supply lines to
7.Connect
8.Attach the shower/massage wand and flow valve. Be sure to use the washers supplied.
9.Check for leaks in supply or drain lines and check operation of tub. Refer to Operating Instructions on page 20.
Invacare® TheraPure™ Recessed Whirlpool Tubs | 18 | Part No. 1167458 |