ASSEMBLY
8LOWER CHUTE
(See Figure 8)
1.Raise and hold deflector shield in upright position.
2.Place slot in lower chute over tab on mower deck and position lower chute over deck opening as shown.
3.Hook rear latch into flange hole on back of mower deck.
4.Hook front latch into tab hole on front of mower deck.
CAUTION
Before raising deflector shield, turn mower engine off. DO NOT remove deflector shield from mower. Raise and hold shield when at- taching lower chute and allow it to rest on chute while in operation.
DEFLECTOR
SHIELD
WASHER
MOWER DECK BAFFLE
WING NUT | HEX BOLT |
FIGURE 8
9HOSE
(See Figures 9A and 9B)
1.Place both clamps over the hose.
2.Slide the hose over the inlet at the top end.
3.Slide the hose over the lower chute inlet.
4.Remove any twists in the hose by rotating it at the top or bottom end.
5.Tighten the clamps.
COVER
HOSE
LOWER
CHUTE
FIGURE 9A
FIGURE 9B
10