|
| ASSEMBLY | ||
4 | INSTALLATION OF THE INLET | MOUNTING COVER ASSEMBLY TO | ||
SUPPORT ASSEMBLY | ||||
|
| |||
(See Figure 4A and 4B) |
| 5(See Figure 5) | ||
1.Place the cover assembly upside down on a table. Secure the six bolts (HCS 1/4 x 3/4), nyloc nuts (1/4) and twelve flat washers (1/4).
2.Place one washer on each bolt.
3.Place the inlet in the cover and direct it out of the large hole on the front side of the cover.
4.Place the bolt and washer thru each of the six holes. See Figure 4.
5.Place the other six washer and nuts on the bolts and tighten.
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting cover assembly to mower.
1.Position cover assembly on ground behind mower as shown.
2.Lift and rotate cover to align cover brackets with support assembly.
3.Slide cover assembly down onto the support assembly.
INSIDE COVER
FIGURE 4A
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
OUTSIDE COVER
FIGURE 4B
FIGURE 5
8