ASSEMBLY
6 CONTAINER ASSEMBLY (See Figure 6)
1.Place bottom half inside of top half, as shown.
2.Place one foot inside bottom half and lift top half to meet bottom half.
3.Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN IN- SET.
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of container and check that there is no gap be- tween upper and lower halves. If a gap appears, unlock tabs to separate container halves and re- peat instructions above.
FIGURE 6
7 CONTAINER MOUNTING (See Figure 7)
1.Install one container to left side first with warning to the outside of unit. Install other container to the right.
NOTE: Right container should always overlap left container at center supports.
2.Close cover and lock latch handles over center support tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
CONTAINER
HANDLE
CENTER
SUPPORT
TUBES
CONTAINER
WARNING
WARNING
DO NOT operate mower unless container is properly installed. Container is subject to wear and deterioration, check contain- ers frequently, replace when cracked or damaged. Use only a recommended re- placement container.
FIGURE 7
9