Homelite F2020 Maintenance, Spool Replacement EZ Line TAP Advance System, NEW PRE-WOUND Spool

Page 12

MAINTENANCE

WARNING:

Use only original manufacturer’s replacement parts, accessories and attachments. Failure to do so can cause possible injury, poor performance, and may void your warranty.

You may make adjustments and repairs described here. For other repairs, have the trimmer serviced by an authorised service dealer.

Consequences of improper maintenance may include excess carbon deposits, resulting in loss of performance and discharge of black oily residue dripping from

the silencer.

Make sure all guards, straps, deflectors and handles are properly and securely attached to avoid the risk of personal injury.

SPOOL REPLACEMENT

EZ LINE™ TAP ADVANCE SYSTEM

NEW PRE-WOUND SPOOL

See Figures 10 and 11.

If replacing string only, refer to “String Replacement” later in this manual.

Use only 2.0 mm (.080 in) diameter monofilament string. Use the manufacturer’s replacement string for best perfor- mance.

1.Stop the engine and disconnect the sparking plug wire. Hold the string head and unscrew the spool retainer. Turn clockwise.

2.Remove the empty spool from the string head. Keep the spring attached to the spool.

3.To install the new spool, make sure the two strings are captured in the slots opposite each other on the new spool. Make sure the ends of each string are extended approximately 152 mm (6 in) beyond each slot.

4.Thread the strings into the eyelets in the string head. Carefully push the spool into the string head (gently pull the strings to the outside if necessary). When the spool is positioned in the string head, grasp the strings and pull sharply to release them from the slots in the spool.

5.Push down and turn the spool anticlockwise until it no longer turns. Hold the spool down and rotate clockwise a small amount. Release the spool. The spool should be locked down in the string head. If not, hold down and rotate until locked.

6.Make sure the string head and the spool retainer are installed on the drive shaft by turning the retainer anticlockwise to tighten.

7.Pull the strings again to rotate the spool into cutting position. Push the spool retainer down while pulling on string(s) to manually advance the string and to check for proper assembly of the string head.

SPOOL

RETAINER

Fig. 10

SPRING

SLOTS

EYELETS

STRING HEAD

DRIVE SHAFT

Fig. 11

12

Image 12
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents SafetySpecific Safety Rules for Trimmer USE Symbols Symbol Name ExplanationTechnical Data Features UnpackingInstructions Packing List for OWNER’S KITAssembly Assembly InstructionsSee Figure BoltSilencer Guard Assembly Fuel and Refuelling Operating the TrimmerHandling the Fuel Safely Mixing the FuelOperation Advancing the StringCutting Tips Grass Deflector Line Trimming CUT- OFF BladeIgnition Switch Starting and StoppingTo Start a Cold Engine To Start a Warm EngineMaintenance Spool Replacement EZ Line TAP Advance SystemNEW PRE-WOUND Spool See Figures 10Cleaning the Exhaust Port and Silencer String ReplacementSpark Arrester Arrows on Spool Anchor Hole First StringReplacing and Cleaning AIR Filter Fuel CAPSparking Plug Storage 1 Month or LongerTroubleshooting Speed. See FigureIdle Speed Screw Mixture Needle Warranty Safety DirectiveGuarantee Statement Rtsa / Rtuk / RTG EC Declaration of ConformityRyobi Technologies GmbH