ASSEMBLY
ASSEMBLY INSTRUCTIONS:
GRASS DEFLECTOR
See Figure 2.
1.Remove wing nut, flat washer, lock washer and bolt from the Owner’s Kit.
2.Place grass deflector over shaft and bracket.
3.Install bolt through the slots in the tabs on grass deflec- tor and bracket on drive shaft housing.
4.Install flat washer, lock washer and wing nut.
5.Tighten Securely.
FRONT HANDLE
See Figure 3.
1.Remove the front handle, bolt and wing nut from the Owner’s Kit.
2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
3.Place the bolt through the front handle as shown. Then install the wing nut.
4.Tighten the wing nut securely.
NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See
Figure 3.
7
BOLT
BRACKET
WING NUT
GRASS DEFLECTOR
FLAT WASHER
LOCK WASHER
WING NUT
Fig. 2
FRONT HANDLE
BOLT
Fig. 3