Homelite UT10510A manual Starting the Engine

Page 12

OPERATION

STARTING THE ENGINE:

3.Set the ignition switch to the RUN (I) position.

4.Fully press and release the PRIMER BULB 7 times.

5.Pull CHOKE lever all the way OUT to full position.

6. While squeezing both the trigger release and throttle trigger, push in the throttle lock button. Release the throttle trigger. This latches the trigger for starting.

CHOKE LEVER

FULL CHOKE

HALF CHOKE

RUN POSITION

Fig. 11

TRIGGER

RELEASE

THROTTLE

LOCK BUTTON

THROTTLE TRIGGER

Fig. 12

STARTER

GRIP

Fig. 13

TRIGGER

RELEASE

THROTTLE TRIGGER

Fig. 14

Page 12

Image 12

Contents Operators Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules General PrecautionsSafety Apparel Basic Precautions in the CUTTING/ Work AreaMaintenance Precautions KickbackPush and Pull See FigureSymbols Symbol Name ExplanationSpecifications Features Understanding Your Chain SAW Safety Devices OperationSAFE-T-TIP ANTI-KICKBACK Nose Guard LOW Kickback SAW ChainKickback Precautions Fuel and RefuelingHandling the Fuel Safely Mixing the FuelAdding OIL Starting the EngineSee Figures 8 through Starting the Engine Stopping the Engine Preparing for Cutting Proper Grip on HandlesProper Cutting Stance See Figures 16Adjusting the Carburetor Basic OPERATING/CUTTING ProceduresWork Area Precautions See Figures 20Adjusting Idle Speed Felling TreesHazardous Conditions Proper Procedure for Tree Felling See Figures 23 throughHinge Removing Buttress Roots BuckingBucking with a Wedge Bucking Logs Under Stress OverbuckingUnderbucking Limbing and Pruning Cutting SpringpolesMaintenance Assembling the BAR and ChainSee Figures 36 through Chain Tensioning PIN Hole Chain Tensioning Screw Adjusting the Chain Tension Chain MaintenanceSee Figures 45, 46, See Figures 48Sharpening the Cutters See Figures 50 throughLeft Hand Cutters Right Hand TOP Plate Filing Angle Side Plate AngleMaintaining Depth Gauge Clearance See Figures 57, 58,Maintaining the Guide BAR Maintaining the SAFE-T-TIP Nose GuardSee Figures 61 Cleaning the AIR Filter Mounting the SAFE-T-TIP Nose GuardSee Figures 63, 64, Cleaning the Starter Unit Cleaning the EngineChecking the Fuel Filter Replacing the Spark PlugCleaning the Spark Arresting Muffler Chain CatcherStoring the Chain SAW 1 Month or Longer BAR and Chain Combinations Troubleshooting Problem Possible Cause SolutionWarranty Limited Warranty StatementOperators Manual