Homelite UT10514/14 IN. 33CC manual Adjusting, Cutters chain rotation Chain drive links

Page 23

maintenance

n Lay out the new saw chain in a loop and straighten any

kinks. The cutters should face in the direction of chain

rotation. If they face backwards, turn the loop over.

n Place the chain drive links into the bar groove as

shown.

n Position the chain so there is a loop at the back of the

bar.

n Hold the chain in position on the bar and place the loop

around the sprocket.

BAR STUDS

aDJUSTING

n Fit the bar flush against the mounting surface so that the

bar studs are in the long slot of the bar.

Note: When placing the bar on the bar studs, ensure

that the adjusting pin is in the chain tension pin hole.

cutters chain rotation

chain drive links

chain tensioning

pin hole

GUIDE BAR

PLATE

SPROCKETCLUTCH

COVER

Fig. 39

Fig. 37

chain tensioning

screw

bar

groove

chain drive links

Fig. 38

Fig. 40

Page 23

Image 23

Contents OPERATOR’S Manual Introduction Table of contentsRead ALL Instructions General safety rulesKickback Specific safety rulesRefueling do not Smoke Symbol Name SymbolsService Glossary of terms Primer bulb Trigger FeaturesProduct Specifications Front hand guard/Chain Brake Handle Cylinder CoverSAFE-T-TIP ANTI-KICKBACK Nose Guard Know Your Chain SAWChoke Lever LOW Kickback SAW ChainPacking List AssemblyOperation UnpackingPremium Exact MIX Handling the Fuel SafelyMixing the Fuel Run Position Brake Operating the Chain BrakeSee Figure See Figures 4See Figures 6 Starting the EngineSee Figures 12 Throttle Lock button Trigger Ignition switchStopping the Engine To Start a Warm EnginePull and Push Adjusting Idle SpeedSee Figures 16 Kickback PrecautionsProper Grip on Handles Thumb on Undersideof Handle bar Straight Chain line Arm Work Area PrecautionsBasic OPERATING/CUTTING Procedures Proper Cutting StanceSee Figures 21 Proper Procedure for Tree FellingHazardous Conditions Vertical Cut Loose SectioN Horizontal Kickback Removing Buttress RootsBucking Overbucking Bucking with a WedgeBucking Logs Under Stress See Figures 31 UnderbuckingLimbing and Pruning Cutting SpringpolesSee Figures 34 MaintenanceGeneral Maintenance LubricationChain tensioning Screw Bar Groove Chain drive links ADJUSTINGCutters chain rotation Chain drive links Chain tensioning Pin holeSee Figures 44 Adjusting the Chain TensionRaker depth gauge clearance 025 Inspect drive Sprocket Chain MaintenanceSee Figures 47 ≈ .050See Figures 49 Sharpening the CuttersSee TOP Plate Filing AngleSide Plate Angle Maintaining Depth Gauge ClearanceSee Figures 59 Maintaining the Guide BARMounting the SAFE-T-TIP Nose Guard Maintaining the SAFE-T-TIP Nose GuardSee Figures 61 Cleaning the AIR FilterChoose one of the following cleaning options See Figures 64 Adjusting the CarburetorCleaning the Starter Unit Before adjusting the carburetorReplacing the Spark Plug Cleaning the EngineClean Cylinder Fins Clean flywheel Fuel filter Checking the Fuel FilterSee Figures 72 Storing the ProductBar and chain combinations TroubleshootingCall US First Limited Warranty Statement WarrantyYour Warranty Rights and Obligations Warranty Serial Number California Proposition