Homelite UT10516/16 IN. 33CC, UT10514/14 IN. 33CC manual California Proposition, Serial Number

Page 38

OPERATOR’S MANUAL

UT10514 / 14 in. 33cc CHAIN SAW

UT10516 / 16 in. 33cc CHAIN SAW

WARNING:

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

CALIFORNIA PROPOSITION 65

SERVICE

For parts or service, contact your nearest Homelite authorized service dealer. Be sure to provide all relevant information when you call or visit. For the location of the authorized service dealer nearest you, please call 1-800-242-4672 or visit us online at www.homelite.com.

REPAIR PARTS

The model number of this product is found on a plate or label attached to the housing. Please record the serial number in the space provided below.

MODEL NUMBER _____________________________ _______

SERIAL NUMBER

HOMELITE CONSUMER PRODUCTS, INC.

1428 Pearman Dairy Road

Anderson, SC 29625

Phone 1-800-242-4672

www.homelite.com

987000-208

5-15-08 (REV:01)

Image 38
Contents OPERATOR’S Manual Table of contents IntroductionGeneral safety rules Read ALL InstructionsKickback Specific safety rulesRefueling do not Smoke Symbols Symbol NameService Glossary of terms Front hand guard/Chain Brake Handle Cylinder Cover FeaturesProduct Specifications Primer bulb TriggerLOW Kickback SAW Chain Know Your Chain SAWChoke Lever SAFE-T-TIP ANTI-KICKBACK Nose GuardUnpacking AssemblyOperation Packing ListPremium Exact MIX Handling the Fuel SafelyMixing the Fuel See Figures 4 Operating the Chain BrakeSee Figure Run Position BrakeStarting the Engine See Figures 6To Start a Warm Engine Throttle Lock button Trigger Ignition switchStopping the Engine See Figures 12Adjusting Idle Speed Pull and PushSee Figures 16 Kickback PrecautionsProper Grip on Handles Proper Cutting Stance Work Area PrecautionsBasic OPERATING/CUTTING Procedures Thumb on Underside­of Handle bar Straight Chain line ArmSee Figures 21 Proper Procedure for Tree FellingHazardous Conditions Vertical Cut Loose SectioN Horizontal Kickback Removing Buttress RootsBucking Overbucking Bucking with a WedgeBucking Logs Under Stress Cutting Springpoles UnderbuckingLimbing and Pruning See Figures 31Lubrication MaintenanceGeneral Maintenance See Figures 34Chain tensioning Pin hole ADJUSTINGCutters chain rotation Chain drive links Chain tensioning Screw Bar Groove Chain drive linksAdjusting the Chain Tension See Figures 44≈ .050 Chain MaintenanceSee Figures 47 Raker depth gauge clearance 025 Inspect drive SprocketSharpening the Cutters See Figures 49Maintaining Depth Gauge Clearance TOP Plate Filing AngleSide Plate Angle SeeMaintaining the SAFE-T-TIP Nose Guard Maintaining the Guide BARMounting the SAFE-T-TIP Nose Guard See Figures 59See Figures 61 Cleaning the AIR FilterChoose one of the following cleaning options Before adjusting the carburetor Adjusting the CarburetorCleaning the Starter Unit See Figures 64Checking the Fuel Filter Cleaning the EngineClean Cylinder­ Fins Clean flywheel Fuel filter Replacing the Spark PlugStoring the Product See Figures 72Troubleshooting Bar and chain combinationsCall US First Warranty Limited Warranty StatementYour Warranty Rights and Obligations Warranty California Proposition Serial Number