THE FREQUENCIES ON YOUR RECEIVER AND TRANSMITTER HAVE BEEN PRESET AT THE FACTORY. BEFORE INSTALLING THE RECEIV- ER, MAKE SURE THE DIP SWITCHES ON THE RECEIVER AND TRANSMITTER ARE SET TO THE SAME FREQUENCY. THE DIP SWITCHES ON THE TRANSMITTER ARE LOCATED INSIDE THE BATTERY COMPARTMENT.
Setting the Code
This unit has 16 different code combinations. To set the code, perform the following steps: A. Setting the code on the transmitter:
a. Remove the battery cover. Press firmly below arrow and slide battery cover off. b. Slide code switches to your choice of up
or down position. (Factory setting is all up). B. Setting the code on the receiver.
a. Slide code switches to the same position as set on your transmitter.
b. Replace battery cover on transmitter.
C. Setting the light function on the transmitter. a. Push the black switch to the left for “No
Dimmer” function.
b. Push the black switch to the right for “Dimmer” function.
CAUTION:
Ceiling angle shall not exceed 30 degrees. Controller Model:
6.
Figure 9
EACH WIRE NUT (WIRE CONNECTOR) SUP- PLIED WITH THIS FAN IS DESIGNED TO ACCEPT UP TO ONE 12 GAUGE HOUSE WIRE AND TWO WIRES FROM THIS FAN. IF YOU HAVE LARGER THAN 12 GAUGE HOUSE WIRING OR MORE THAN ONE HOUSE WIRE TO CONNECT TO THE FAN WIRING, CONSULT AND ELECTRICIAN FOR THE PROPER SIZE WIRE NUTS TO USE.
Finishing the Fan Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD MOUNTING, THE TAB IN THE RING AT THE BOT- TOM OF THE MOUNTING PLATE MUST REST IN THE GROOVE OF THE HANGER BALL. FAILURE TO PROPERLY SEAT THE TAB IN THE GROOVE COULD CAUSE DAMAGE TO WIRING.
1.Align the locking slots of the ceiling canopy with the two screws in the mounting plate. Push up to engage the slots and turn clock- wise to lock in place. Immediately tighten the two mounting screws firmly.
2.Install the remaining two mounting screws into the holes in the canopy and tighten firmly.
3.Install the decorative canopy ring by aligning the ring’s slots with the screws in the canopy. Rotate the ring counter- clockwise to lock in place.
4.You may now proceed to attaching the fan blades.