Motor Wires |
| |
Ball/Downrod |
| |
Assembly |
| |
Canopy |
| |
Canopy | Pin in | |
Locked | ||
Ring | ||
Position | ||
Motor Collar | ||
| ||
Cover |
| |
Hanger | Locking | |
Pin | ||
Pin | ||
Motor | ||
Tighten | ||
Collar | ||
Screws | ||
Reversing | ||
| ||
Switch |
| |
| Figure 7 |
Installing Fan to the Outlet Box
WHEN MOUNTING THE FAN ON A SLOPED CEILING, THE STANDARD BALL/DOWNROD MOUNTING METHOD MUST BE USED. THE MOUNTING PLATE MUST BE MOUNTED SO THAT THE SLOT OPENINGS ARE ON THE LOWER SIDE BY SLIDING THE MOUNTING PLATE FROM THE TOP DOWN.
1.Pass the
2.Install the ceiling mounting plate on the out- let box, by sliding the mounting plate over the two screws provided with the outlet box (Figure 8). If necessary, use leveling wash- ers (not included) between the mounting plate and the outlet box. Note that the flat side of the mounting plate is toward the out- let box (Figure 8).
3.Securely tighten the two mounting screws.
4.Carefully lift the fan assembly up to the ceiling mounting plate. Make sure the tab on the mounting plate is properly seated in the groove in the hanger ball.
Figure 8 |
Making the Electrical Connections
REMEMBER to disconnect the power. If you feel you do not have enough electrical wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan to your household wiring. Use the wire connecting nuts supplied with your fan and supplied with remote control. Se- cure the connectors with electrical tape. Make sure there are no loose strands or connections (Figure 9).
1.Connect both green wires from the down- rod and mounting plate to the bare copper (Ground) from the outlet box
2.Connect the black wire (AC IN L) from the receiver unit to the black wire from the outlet box.
3.Connect the white wire (AC IN N) from the receiver unit to the white wire from the outlet box.
4.Connect the white wire (To Motor N) from the receiver unit to the white wire from the fan assembly.
5.Connect the black wire (To Motor L) from the receiver unit to the black wire from the fan assembly.
After wires are connected, carefully tuck them into the outlet box. Insert the receiver unit into the mounting plate; make sure the black antenna wire sits on top of the receiver unit.
5.