Assembly (continued)
Connecting the Rail Assembly (2) to the Oil Tank Assembly (10B)
1.Insert the Front Leg Assembly (11) into the bracket on the Oil Tank Assembly (10B). Insert the remaining Hex Head Bolt (16) through the hole in the middle of the bracket of the Oil Tank Assembly (10B). Secure it with a Hex Head Nut (17). Refer to the Hex Head Nut (17) attached to the Hex Head Bolt (16) at the top of the Front Leg Assembly (11) in FIGURE 1 below. Note: When travelling, remove the Push Pin (26) and Hair Pin Clip (29) and lift the Front Leg Assembly up so that it is parallel to the Rail Assem- bly (2). Then, replace the Push Pin (26) and Hair Pin Clip (29) into the Horizontal Transport Hole shown just above the Oil Plug (37), in FIGURES 1 and 2.
2.To connect the Rail Assembly (2) to the Oil Tank Assembly (10B), insert a Hex Head Bolt (16) into the middle hole of the “L” shaped bracket on the Oil Tank Assembly (10B). Secure it with a Hex Head Nut (17). Refer to the Hex Head Nut (17) attached to the Hex Head Bolt (16) just above the tire in FIGURE 1 below. Insert the Push Pin (26) through the hole, as shown in FIGURE 3.
3.In FIGURES 1 and 2, the Rail Assembly (2) is shown in Horizontal mode for operation and travel (as mentioned above, the Front Leg Assembly (11) must be secured up in the horizontal position when travelling). For vertical operation see page 6.
FIGURE 1
Slide Assembly (3)
Safety Chain | Cylinder (1) | ||
with Hook (4) | |||
|
| ||
|
|
| |
Base
Place Log Here
Hitch Coupler (9)
Hex Head Nut (17) is attached to Hex Head Bolt (16)
Horizontal transport hole
Push Pin (26) and
Hair Pin Clip (29)
Front Leg Assembly (11)
Oil Tank (10B)
Push Pin (26)
Oil Plug (37) with air inlet hole
Oil Removal Plug
Wheel Cap (61) 
Rail Assembly (2)
Vertical Position Hole
Hex Head Nut (17) is attached to Hex Head Bolt (16)
Vertical position locking hole
FIGURE 2
Horizontal transport hole
FIGURE 3
Second Push Pin (26) secures Rail Assembly (2), and is removed for vertical log splitting.
Air Inlet Hole 
Push Pin (26)
Oil Plug (37) with air inlet hole
SKUs | 91839, 91840 | For replacement parts, please call | Page 5 |
| & 92199 |
|
|