21.This equipment must never be used in any sealed structure. Carbon mon- oxide is produced during operation and is DEADLY in a closed environment. Early signs of carbon Monoxide poisoning resemble the flu, with headaches, dizziness, or nausea. If you have these signs, the tool may not be working prop- erly or is improperly vented, get fresh air immediately.
22.Never split a log that contains any foreign materials.
23.WARNING: The brass components in this product contain lead, which is a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. (California Health & Safety Code § 25249.5, et seq.)
24.People with pacemakers should consult their physician(s) before using this prod- uct. Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker.
Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 9 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Assembly
Note: Because of the weight and size of the Log Splitter, assembly should be done with the help of another person.
Attaching the Tires
Refer to the Assembly Drawing on page 9 and FIGURE 1 on page 5.
1.Position the Tires (48) next to each of the Axles located on the bottom of the Oil Tank Assembly (10). The Tires (48) come completely assembled.
2.Make certain to pack the bearings as explained in the included insert.
3.Put a Seal (59) and Bearing (49) on the Axle and then put the Tire (48) on the Axle.
4.Follow the Bearing Packing Instructions as explained on the last page of this manual. With each Tire (48) in place, add a Washer (50) and a Spindle Nut (51) onto the ends of the Axles. Tighten the Spindle Nuts (51) to
The Tire (48) assembly is now complete. Note: It may be necessary to reset the wheel bearings after the Log Splitter has been towed.
The wheel manufacturer states the maximum speed is not to exceed 40 MPH. The tires are DOT approved for public roads; however, this item is not for use on public roads or highways.
SKUs | 91839, 91840 | For replacement parts, please call | Page 4 |
| & 92199 |
|
|