Marantz SR6009 owner manual Input Select, Input Mode, Decode Mode, Digital, 1CH

Contents Connections Playback Settings Tips Appendix

Input Select

Set the audio input mode and decode mode of each input source.

The input modes available for selection may vary depending on the input source.

“Input Select” settings are stored for each input source.

oInput Mode

Set the audio input modes for the different input sources.

It is normally recommended to set the audio input mode to “Auto”.

Auto	Automatically detect input signal and
(Default):	perform playback.
HDMI:	Play only signals from HDMI input.
Digital:	Play only signals from digital audio input.
Analog:	Play only signals from analog audio input.
7.1CH IN:	Only signals input from the 7.1CH IN
	connector will be played back.

0If “HDMI Control” is set to “On” and a TV compatible with the ARC is connected via the HDMI MONITOR connectors, the input mode whose input source is “TV Audio” is fixed to ARC.

0The sound mode cannot be set if the input mode is set to “7.1CH IN”.

oDecode Mode

Set the audio decode mode for input source.

It is normally recommended to set the audio input mode to “Auto”. But we recommend changing it to “PCM” or “DTS” if the start of the source is clipped or noise occurs.

Auto	Detect type of digital audio input signal
(Default):	and decode and play automatically.
PCM:	Decode and play only PCM input signals.
DTS:	Decode and play only DTS input signals.

This item can be set for input sources for which “HDMI” or “DIGITAL” is assigned at “Input Assign” (v p. 175).

Front panel Display Rear panel 178 Remote Index