Fisher 1270 manual NO- Motion Pinpoint, Figure #3

SEARCH TECHNIQUES

NO- MOTION PINPOINT

1.When the target “beep” is heard, make an “X” over the target, as de- scribed above, to determine the target area.

2.Move the coil away from the target area, and lower the coil to the ground.

3.Pull, and hold the MODE TRIGGER switch.

4.Raise the coil about 1/2 inch; move back across the target area.

5.Stop the coil at the center of the loudest response.

6.Repeat this one more time, moving your coil from side to side. Your target should be directly below the center of the coil.

7.For larger targets, place the coil on the ground, closer to the center of the target. The closer you are to the target center when you pull the MODE TRIGGER switch, the more of the target will be “tuned-out”. The target signal response will appear smaller and even easier to pinpoint.

8.IMPORTANT: Be careful not to pull the Pinpoint MODE TRIGGER switch while directly over the target. This may “tune-out” the entire tar- get, and you will get no target response.

Figure #3

Figure #4

11