Honeywell DR4300 manual Error Messages, Troubleshooting and Pen Alignment Recorder with Display

				Troubleshooting and Pen Alignment
					of Recorder with Display
		Table 8-4 Error Messages
Lower Display
Indication	Type of Test	Reason For Failure		How to Correct the Problem
CALERR	power-up	The working calibration constants	1. Use the procedure in Subsection 4.5.2.5
	background	in the recorder are in error or	to switch between the set of calibration
		corrupted in memory.	constants being used (factory or field) to
			the other type. Exit configuration mode.
			Next go back into configuration mode and
			change back to the original type of
			constants used (factory or field). This will
			overwrite the corrupted values in memory.
			2. Change the setting of the “IN TYP”
			parameter and exit configuration mode.
			Go back into configuration mode and
			change the “IN TYP” setting back to the
			correct type.
CFGERR	power-up	Configuration data is in error.	1. Check all configuration parameter values
	background		for accuracy. (See Section 4 –
			Configuration, Startup, and Operation of
			Recorder with Display.)
			2. Make a change to configuration, then exit
			configuration, so the recorder will
			recalculate the checksum error.
EEFAIL	background	Unable to write to nonvolatile	1. Try to change something in configuration.
		memory. Anytime you change a	2. Cycle the power.
		parameter and it is not accepted,
		you will see EE FAIL.	3. If problem persists, replace printed circuit
			assembly for the channel.
FAILSF	power-up	This error message is displayed	1. Check the operation of the input sensor.
	background	whenever the recorder is using	2. Run through STATUS check to
		the value of the control group
		“FAILSF” parameter as an output.	determine the reason for the failure.
		For this to occur, the recorder	•	Press the		key until
		must have control enabled			SET UP
		(control group parameter		STATUS appears in the lower display.
		“CONTRL” = “ENAB”) when one
		or more of the following occur:
			•	Press the	FUNC	key to see what
		• RAM test fails
				tests pass or fail, then run through the
		• Configuration test fails
		• Calibration test fails		STATUS codes a second time to see
		• Input parameter		if the error cleared.
		“BRNOUT” = “NONE” and the	• Correct according to the
		input fails.
				recommendations given in this table.

12/03 DR4300 Circular Chart Recorder Product Manual 177