Honeywell DR4300 Chart Parameters Set Up Group, Chart group prompts, Chart Parameter Definitions

DR4300 Circular Chart Recorder

4.3.9 Chart Parameters Set Up Group

Introduction

The functions in this group are used to specify proper chart function. For a 2-pen recorder the desired input channel is displayed on the left side of the operator interface.

Press FUNC key to select channel.

Chart group prompts

Table 4-7lists all the function prompts in the chart parameters set up group.

Press SET UP key until “CHART” appears in the lower display.

Press FUNC key to display parameters.

Table 4-7 Chart Parameter Definitions

Lower Display	Upper Display			Parameter
Prompt	Range of Setting			Definition
	or Selection
CHTSPD		CHART SPEED—This is the time it will take to drive the
		chart one complete revolution.
			ATTENTION	This prompt only appears for pen 1
		configuration of a two-pen recorder.
	8HR	8 hour revolution
	12HR	12 hour revolution
	24HR [factory setting]	24 hour revolution
	7DAYS	7 day revolution
	– HR	– hour revolution—specify Hours per Revolution selection
		at prompt “HR/REV”.
HR/REV	1 to 744 Hours	HOURS PER REVOLUTION—Set the desired chart
		speed. Appears only if – HR was selected at prompt
		“CHTSPD”.
CHTTYP		CHART TYPE—Selection is based on the type of chart.
	LIN [factory setting]	Linear (even) or
	NLIN	Non-Linear (i.e., J T/C or RTD)
			ATTENTION	LIN chart type is automatically selected
		when input type is linear (as defined by value of input set
		up parameter “INTYP”).

90 DR4300 Circular Chart Recorder Product Manual 12/03