Honeywell DR4300 manual Auxiliary Output Set Up Group, Auxiliary output group prompts, Auxout

Configuration, Startup, and Operation of Recorder with Display

4.3.16 Auxiliary Output Set Up Group

Introduction

The auxiliary output set up group lets you enable or disable the auxiliary output selection which provides a milliampere output representing one of four control parameters: Input, Output, Setpoint, or Deviation. You can also set the auxiliary output low and high scaling factors.

Auxiliary output group prompts

Table 4-14lists all the function prompts in the auxiliary output set up group and their definitions. For a 2-pen recorder, the desired input channel is displayed on the left side of the operator interface.

Press FUNC to select channel.

Press SETUP key until “AUX OUT” appears in the lower display.

Press FUNC key to select the parameters.

Table 4-14 Auxiliary Output Parameter Definitions

Lower Display	Upper Display	Parameter
Prompt	Range of Setting	Definition
	or Selection
AUXOUT		AUXILIARY OUTPUT SELECTION provides an mA
		output representing any of four control parameters. The
		display for Auxiliary Output viewing will be in engineering
		units for all but output. Output will be designated in
		percent (%).
		The Auxiliary Output is the same output as the Current
		Output and is not available if the control output algorithm
		= CUR, CurT, or Tcur.
		Other prompts affected by these selections: “4 mA VAL”
		and “20mA VAL”.
	NONE [factory setting]	NO AUXILIARY OUTPUT
	INP	INPUT—This represents the configured range of input.
		FOR EXAMPLE:
		Type “J” Thermocouple (0 °F to 1600 °F)
		0 °F display = 0 % output
		1600 °F display = 100 % output
	OUT	OUTPUT—Represents the displayed controller output in
		percent (%).
	SP	SETPOINT—Represents the value of the setpoint in units
		of PV.

12/03 DR4300 Circular Chart Recorder Product Manual 109