Honeywell DR4300 manual Startup procedure Procedure, Procedure for Starting the Recorder

DR4300 Circular Chart Recorder

4.4.4.5 Startup procedure

Procedure

Use the procedure listed in Table 4-25to start the recorder.

Open the recorder door (if the recorder does not have the optional keypad on the outside of the door). Apply power and wait for the recorder to run its power-up tests.

ATTENTION

If FAILSF or another error message starts blinking in the lower display, refer to Section 8 for troubleshooting information.

For recorders with control on both pens, be sure the INP ‘1’ indication is lit for steps 2 to 6. If INP 1

is not lit, press the FUNC key until “1” is lit when “INP” is displayed.

Table 4-25 Procedure for Starting the Recorder

Step Operation Press Action/Result

1	Pen check		For models without outputs, check that the pen is
			operating and skip to Step 4.
2	Select manual		Until “M” indicator is ON. Be sure INP 1 indicator is lit.
		MAN
	mode
		AUTO	If it is not, press		FUNC			key. The recorder is in
		RESET
			manual mode and the Output (OT) in percent is
			displayed in the lower display.
			Calls up OT value in the lower display.
		DISP
3	Adjust the output		Adjust the output value and ensure that the final
		or	control element is functioning correctly.
				Upper Display
						shows the input value.
				Lower Display
							shows OT and the output
							value in %.
4	Confirm correct		If you want to check the recorder’s configuration, follow
		SET
	configuration.		the procedure described earlier in this section. If you
		UP
			try to change a value and can not, a lockout is
			enabled; see Subsection 4.3.19.

126 DR4300 Circular Chart Recorder Product Manual 12/03