Honeywell DR4300 manual SW6 Input Switch

DR4300 Circular Chart Recorder

4.3.5.2 Setting SW6 Input Switches

SW6 switches 1, 3, 4, 5, 6 define input type

In a recorder model having a display and keypad the input switches at SW6 must be set to match the type of input to be used. The location of SW6 is shown in Figure 4-3.The appropriate switch settings for the various input types are shown in Table 4-3.

Note that the setting of switch 2 in SW6 is not related to input type. It is used, along with the “BRNOUT” parameter in the input group, to specify the effects of an input failure as described in Subsection 4.3.5.3.

ATTENTION

The ON position for SW6 switches is toward the left side of the printed circuit assembly (when facing recorder.)

Table 4-3 SW6 Input Switch Settings for Models

Having Display and Keypad

		Input Type		SW6 Input Switch Settings
			1		2	3	4	5	6
0	V to 1	V	off			off	ON	off	off
0	V to 2	V	off			off	ON	off	off
0	V to 5	V	off			off	ON	off	off
0	V to 10 V		off			off	ON	off	off
2	V to 10 V		off			off	ON	off	off
1	V to 5	V	off			off	ON	off	off
0 mV to		10 mV	off			off	off	ON	off
0 mV to		100 mV	off			off	off	ON	off
0 to 200 mV			ON			off	off	off	off
0 mA to		20 mA	off			off	ON	off	ON
4 mA to		20 mA	off			off	ON	off	ON
all thermocouples			off			off	off	ON	off
all RTDs			off		off	ON	off	ON	off

This switch is used to select whether the input value used by the recorder should be driven over range or under range in case of input failure. See Subsection 4.3.5.3.

SW6 Input Switch

ON			6
	5
			4
			3
		2
		1

80 DR4300 Circular Chart Recorder Product Manual 12/03