Switching On and Off
Switching On
1.Turn on the main power switch on the right hand side of the projector. The projector enters the low power Standby status. The indicator light on the left hand side of the projector turns red and the status display next to it shows . .
2.Press any of the numeric keys
3.The indicator light turns green and red and the status display shows 88 for a while.
4.When the projector is ready for use an image appears on screen (this can take approximately one minute).
5.If a valid signal is detected, an image appears on the screen, otherwise a black screen with a “No Signal” message is displayed.
Switching Off
1.Press and hold the Off key on the remote control or the I/O button on the projector keypad.
The indicator light flashes green and red to indicate that the projector is cool- ing down. Cooling fans remain on for approximately four minutes to cool the lamp. In the meanwhile the projector cannot be turned on again.
2.After cooling is complete the projector enters Standby status. The indicator light turns solid red and the status display turns black, unless an error or
warning code is displayed.
Warning: Wait for the cooling fans to turn off before turning off the main power switch or unplugging the projector.
3 Installation | Lumis |
| User Guide |
18
