Sim2 Multimedia 3D-S Setup, Y/C Delay, Signal Range, Lamp Power, Orientation, Keystone, RGBS Sync

manually and move sufficiently close to the screen to observe the effects of the ad- justments.

Y/C Delay

Where Video signals are concerned, use this adjustment to correct horizontal color misalignment within the projected image. For a given video standard (for example PAL or NTSC) the stored value does not normally require further adjustment, unless the source or connection cable is changed.

Signal Range

Determines the signal data range of HDMI signals. It is available when the HDMI signal comes from a RGB source or when the AVI (Auxiliary Video Information) infoframe of the HDMI signal is missing or inconsistent.

•Auto determines the signal range using the information provided by the AVI infoframe of the HDMI signal. If the AVI infoframe is missing or incosistent, the projector uses values 0-255. Auto (which is the default setting) usually selects the correct signal range but you can force either 16-235 or 0-255

•16-235sets black at R, G, B = 16 and white at R, G, B = 235, to match the lu- minance values of digital component standards

•0-255sets black at R, G, B = 0 and white at R, G, B = 255

Lamp Power

Use this control to adjust the lamp output level in 10 W increments from 230 W to 280 W. Lower values decrease brightness but extend the life of the lamp.

Setup

This menu section provides access to installation adjustments.

Orientation

Selects the orientation of the projected image. Available settings are: Floor, Ceiling, Floor Rear and Ceiling Rear.

Keystone

This adjustment compensates the distortion resulting from the angle of projection. Note: Keystone may cause artifacts in the image and may not be available when dis- playing specific 3D content (see Table 4.2). SIM2 recommends that you use this fea- ture only when necessary.

Variable Iris

Controls the iris in the the optical engine. Larger values increase brightness and smal- ler values increase contrast in the projected image.

RGBS Sync

This setting indicates where the sync relative to the RGB signal is supplied. Choose:

•HV when the HV connector is used for the RBGS sync signal

•Video when the RGB sync signal originates from a SCART outlet (via the SCART/R-G-B-sync conversion cable). In this case the R, G and B signals are connected to the specific RCA connectors and the sync signal is connected to the Video input

4 Operation	Lumis 3D-S	29
	User Guide