Sim2 Multimedia 3D-S Location, Mounting, Installation Type, Lens Type, Cooling, Power Outlets

3 Installation

This section provides instructions for the installation of the Lumis 3D-S projector. Important: Installation procedures should be performed by a qualified AV system spe- cialist.

Location

When installing the Lumis 3D-S projector, take the following considerations into ac- count.

Installation Type

Select the installation type that best suits your needs:

•front or rear projection

•floor or ceiling mount

Lens Type

Choose the desired distance from the screen and select the lens type (T1, T2 or T3) that determines the desired screen size.

Cooling

Make sure that the planned location for the projector has adequate ventilation. Check that room temperature is below 35° C and that the projector is away from heating vents. Ensure a minimum 0.25 m (10 in.) clearance on the left, right and rear sides of the projector.

Power Outlets

Verify that the powers outlets are grounded and preferably shielded from power surges and fluctuations. A UPS is optional. Lumis 3D-S power supply operates on any nominal line voltage between 100-240 V AC, 50-60 Hz.

Cables

Check planned cable lengths for video and control cables and make sure these lengths do not exceed specifications.

Ambient Light

Avoid or minimize light sources directed at the screen to preserve the quality of the projected image.

Mounting

The projector can be Floor mounted (upright) or Ceiling mounted (inverted). Choose the method that best suits your installation.

Important: The projection lens is not centered to the chassis (it is off-center horizont- ally by 75 mm or 2.95 in., see “Dimensions” on page 40 for details). Make sure the centerline of the lens is centered horizontally to the center of the screen.

Floor Mounting

Position the projector on a secure and flat surface (such as a table or a shelf). Adjust the three feet at the bottom of the projector until the projector is level on all sides.

3 Installation	Lumis 3D-S	13
	User Guide